Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 3 Oct 2002 19:45:02 -0700
From:      Will Andrews <will@csociety.org>
To:        phk@FreeBSD.org
Cc:        current@FreeBSD.org
Subject:   Re: GEOM && -CURRENT on sparc64
Message-ID:  <20021004024502.GI69627@procyon.firepipe.net>
In-Reply-To: <20021003224141.GD69627@procyon.firepipe.net>
References:  <20021003224141.GD69627@procyon.firepipe.net>

next in thread | previous in thread | raw e-mail | index | archive | help
On Thu, Oct 03, 2002 at 03:41:41PM -0700, Will Andrews wrote:
> FreeBSD 5.0-CURRENT #3: Sat Aug 17 16:48:56 EDT 2002
>     will@oberon.firepipe.net:/usr/src/sys/sparc64/compile/OBERON

As some of you might have been able to tell, this is an old
kernel.  For whatever reason, the kernel wasn't getting built
(even though its dependent objects were), so when I ran "make 
install" it installed the older kernel...

Here's the actual dmesg from a recent -CURRENT...

Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #0: Thu Oct  3 22:10:30 EST 2002
    will@oberon.firepipe.net:/usr/src/sys/sparc64/compile/OBERON
Preloaded elf kernel "/boot/kernel/kernel" at 0xc040a000.
Timecounter "tick"  frequency 502000000 Hz
cpu0: Sun Microsystems UltraSparc-IIe Processor (502.00 MHZ CPU)
nexus0: <OpenFirmware Nexus device>
pcib0: <U2P UPA-PCI bridge> on nexus0
pcib0: sabre: impl 0, version 0: ign 7c0 DVMA map: 0xc0000000 to 0xdfffffff
device 0/12/0: latency timer 64 -> 82
pcib0: ofw_pci_init: no interrupt mapping found for 0/12/0 (preset 0)
pcib0: ofw_pci_init: no interrupt mapping found for 0/7/0 (preset 0)
device 0/12/1: latency timer 64 -> 82
pcib0: ofw_pci_init: mapping intr for 0/12/1 to 6 (preset was 0)
device 0/12/2: latency timer 64 -> 82
pcib0: ofw_pci_init: mapping intr for 0/12/2 to 28 (preset was 0)
device 0/12/3: latency timer 64 -> 82
pcib0: ofw_pci_init: mapping intr for 0/12/3 to 36 (preset was 0)
pcib0: ofw_pci_init: no interrupt mapping found for 0/3/0 (preset 0)
device 0/8/0: latency timer 64 -> 16
pcib0: ofw_pci_init: mapping intr for 0/8/0 to 35 (preset was 0)
device 0/13/0: latency timer 64 -> 16
pcib0: ofw_pci_init: mapping intr for 0/13/0 to 12 (preset was 0)
PCI-PCI bridge at 0/5/0: setting bus #s to 0/1/1
pcib0: ofw_pci_init: descending to subordinate PCI bus
device 0/19/0: latency timer 64 -> 66
pcib0: ofw_pci_init: mapping intr for 0/19/0 to 15 (preset was 15)
pci0: <PCI bus> on pcib0
pci0: <old, non-VGA display device> at device 3.0 (no driver attached)
pcib1: <PCI-PCI bridge> at device 5.0 on pci0
pci1: <PCI bus> on pcib1
isab0: <PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
pci0: <multimedia, audio> at device 8.0 (no driver attached)
ebus0: revision 0x01
ebus0: <idprom>: incomplete
ebus0: <PCI-EBus3 bridge> mem 0xf1000000-0xf17fffff,0xf0000000-0xf0ffffff at dev
ice 12.0 on pci0
ebus0: <flashprom> addr 0-0xfffff (no driver attached)
eeprom0: <EBus EEPROM/clock> addr 0x100000000-0x100001fff on ebus0
eeprom0: model mk48t59
eeprom0: hostid 809fd225
gem0: <Sun ERI 10/100 Ethernet Adaptor> mem 0x400000-0x41ffff irq 6 at device 12
.1 on pci0
miibus0: <MII bus> on gem0
ukphy0: <Generic IEEE 802.3u media interface> on miibus0
ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
gem0: Ethernet address: 08:00:20:9f:d2:25, 2KB RX fifo, 2KB TX fifo
using internal phy
pci0: <serial bus, FireWire> at device 12.2 (no driver attached)
pci0: <serial bus, USB> at device 12.3 (no driver attached)
atapci0: <AcerLabs Aladdin ATA66 controller> port 0xa20-0xa2f,0xa08-0xa0b,0xa10-
0xa17,0xa18-0xa1b,0xa00-0xa07 irq 12 at device 13.0 on pci0
ata2: at 0xa00 on atapci0
ata3: at 0xa10 on atapci0
pci0: <display, VGA> at device 19.0 (no driver attached)
Timecounters tick every 10.000 msec
Initializing GEOMetry subsystem
ad0: 19092MB <ST320011A> [38792/16/63] at ata2-master UDMA66
ad1: 38172MB <MAXTOR 6L040J2> [77557/16/63] at ata3-master UDMA66
Mounting root from ufs:/dev/ad1a

regards,
-- 
wca

To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-current" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20021004024502.GI69627>