Date: Sun, 16 Apr 1995 10:41:14 -0500 (CDT) From: bob@obiwan.pmr.com (Bob Willcox) To: phk@ref.tfs.com (Poul-Henning Kamp) Cc: jkh@freefall.cdrom.com, kargl@crosby.apl.washington.edu, bde@zeta.org.au, freebsd-current@FreeBSD.org Subject: Re: 0412-SNAP is FUBAR Message-ID: <m0s0WRn-00030eC@obiwan.pmr.com> In-Reply-To: <199504152124.OAA22122@ref.tfs.com> from "Poul-Henning Kamp" at Apr 15, 95 02:24:35 pm
next in thread | previous in thread | raw e-mail | index | archive | help
Poul-Henning Kamp wrote: > > > > When is the scsi version of the slice code scheduled for prime time use? > > > > The minute you see the commit messages go into sysinstall saying > > "make this utility understand slices" :-) > > > > More like, "you can grab the sd.c and wd.c from current and recompile > your kernel". > > Sysinstall is only a tool for loading FreeBSD onto the disk, the kernel > is all fine and ready to use slices. > > Problem is, until we fix sysinstall, we cannot use the "new" sd.c and wd.c > on the distribution :-( What version of the aic7xxx device driver is on the 412 snap? I have found that I can't use my AHA-2740A SCSI adapter on this snap, though -current is working ok. If I attempt to install with this adapter I get a panic. I went ahead and installed with my BusLogic BT-747S adapter without problems but when I switch to the Adaptec I also get a similar (I didn't take notes of the install panic, sorry) panic: Fatal trap 12: page fault while in kernel mode fault virtual address = 0xf06539fa fault code = supervisor write, page not present instruction pointer = 0x8:0xf019cb1d code segment = base 0x0, limit 0xfffff, type 0x1b DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = Idle interrupt mask = net tty panic: page fault syncing disks... Fatal trap 12: page fault while in kernel mode fault virtual address = 0x1b fault code = 0x8:0xf01215eb code segment = base -x0, limit 0xfffff, type 0x1b DBL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = Idle interrupt mask = net tty bio panic: page fault This occurs following the ed1: .... multi-line stuff on the console. Note that fsck's have been done by this time so the adapter and drive (its a Micropolis 2217) seem to be working fine. One last thing. With both the Adaptec and BusLogic adapters in the machine (this is how I run it under -current) the floppy disk boot sequence hangs right after the warning about there being no swap space. -- Bob Willcox bob@obiwan.pmr.com (or obiwan%bob@uunet.uu.net) Austin, TX
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?m0s0WRn-00030eC>