Date: Thu, 07 Jun 2007 13:11:20 +0200 From: Ian FREISLICH <ianf@clue.co.za> To: Pyun YongHyeon <pyunyh@gmail.com> Cc: current@freebsd.org Subject: Re: if_msk "failed to allocate DMA'able memory for jumbo buf" Message-ID: <E1HwFtg-0000O9-M3@clue.co.za>
next in thread | raw e-mail | index | archive | help
>On Thu, Jun 07, 2007 at 11:18:00AM +0200, Ian FREISLICH wrote: > > Hi > > > > On a Macbook Pro, I can't get the onboard wire Nic to work: > > > > mskc0: <Marvell Yukon 88E8053 Gigabit Ethernet> port 0x2000-0x20ff mem 0x982 00000-0x98203fff irq 16 at device 0.0 on pci2 > > msk0: <Marvell Technology Group Ltd. Yukon EC Id 0xb6 Rev 0x02> on mskc0 > > msk0: failed to allocate DMA'able memory for jumbo buf > > device_attach: msk0 attach returned 1 > > mskc0: [FILTER] > > > > none2@pci2:0:0: class=0x020000 card=0x532111ab chip=0x436211ab rev=0x22 hdr= 0x00 > > vendor = 'Marvell Semiconductor (Was: Galileo Technology Ltd)' > > device = 'Yukon 88E8053 PCI-E Gigabit Ethernet Controller (Copper)' > > class = network > > subclass = ethernet > > cap 01[48] = powerspec 2 supports D0 D1 D2 D3 current D0 > > cap 03[50] = VPD > > cap 05[5c] = MSI supports 2 messages, 64 bit > > cap 10[e0] = PCI-Express 1 legacy endpoint > > > >Did you try to reload msk(4) kernel module? >If yes then there is no way to recover from this without rebooting. :-( I only tried loading the module after boot. I see now that it works if it's loaded from loader.conf. Ian -- Ian Freislich
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?E1HwFtg-0000O9-M3>