Date: Fri, 04 Aug 2000 12:08:19 +0200 From: Wouter de Bie <DeBie@stone-it.nl> To: freebsd-hardware@freebsd.org Subject: Stallion EasyConnect 8/64 and FreeBSD Message-ID: <398A9613.BCA1564D@stone-it.nl>
next in thread | raw e-mail | index | archive | help
Hi!
Right now I'm configuring a FreeBSD system with a Stallion EasyConnect
8/64. Since this is the first time I've worked with FreeBSD, I'm trying
to find my way around. I do have my basic UNIX knowledge, because I work
with Linux as a sysadmin.
Now to the point. I read the manual about configuring the system with
the EasyConnect (a multiport board, where you can connect 64 terminals).
I configured the kernel, but the manual says:
"Add board probe entries into the kernel configurationfile:
(..) if only using PCI boards then you don't need to enter a
configruation line,
the kernel will automatically detect the board at boot up, so
skip to
step 5.
(..)
5. Build a new kernel using this configuration."
So I compiled the kernel, installed it, rebooted, but the card wasn't
detected. And it gives me:
"pci0: <unknown card> (vendro=0x124d, dev=0x0002) at 4.0 irq 11"
When I insert "device stl" into my kernelconfig, nothing happens either.
I also tried putting the card into another PCI-slot and also tried the
GENERIC kernel.
Anyone who can help me?
Greetings,
Wouter de Bie
Stone IT B.V.
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-hardware" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?398A9613.BCA1564D>