Date: Fri, 18 Sep 1998 18:01:48 +0200 From: "Johan Granlund" <johan@granlund.nu> To: freebsd-current@FreeBSD.ORG Subject: CAM and exabyte EXB-8200 problems Message-ID: <199809181605.SAA00314@phoenix.granlund.nu>
next in thread | raw e-mail | index | archive | help
Hi I got a small problem (TM) after uppgrading to CAM, my tapestation is hanging on boot. This is an old Exabyte 8200. When looking at a boot -v it hangs when all devices EXCEPT the tapestation has been found. This is a fullblown SCSI hang with the busylamp on The exabyte is doing a lengthy recalibration on a SCSI reset. When looking on the output from a preCAM boot i got a couple of busy timeouts. SCSI_DELAY=30000 (30sec) Is appendig two boot -v outputs one precam (beetwen E-Day and C-Day) and one without the tape from today at 17:00 CEDT Any solutions? /Johan ------------------------------------------------------- Kernel from 98-09-06 Sep 17 19:25:47 phoenix /kernel.stable: ahc0: <Adaptec 2940 Ultra SCSI host adapter> rev 0x00 int a irq 10 on pci0.15.0 Sep 17 19:25:47 phoenix /kernel.stable: ahc0: aic7880 Wide Channel, SCSI Id=7, 16/ Sep 17 19:25:47 phoenix /kernel.stable: 255 SCBs Sep 17 19:25:48 phoenix /kernel.stable: ahc0: waiting for scsi devices to settle Sep 17 19:25:48 phoenix /kernel.stable: scbus0 at ahc0 bus 0 Sep 17 19:25:48 phoenix /kernel.stable: ahc0: target 0 Tagged Queuing Device Sep 17 19:25:48 phoenix /kernel.stable: sd0 at scbus0 target 0 lun 0 Sep 17 19:25:48 phoenix /kernel.stable: sd0: <SEAGATE ST11900N 8650> type 0 fixed SCSI 2 Sep 17 19:25:48 phoenix /kernel.stable: sd0: Direct-Access 1621MB (3320691 512 byte sectors) Sep 17 19:25:48 phoenix /kernel.stable: ahc0: target 1 Tagged Queuing Device Sep 17 19:25:48 phoenix /kernel.stable: sd1 at scbus0 target 1 lun 0 Sep 17 19:25:48 phoenix /kernel.stable: sd1: <HP C3725S 5153> type 0 fixed SCSI 2 Sep 17 19:25:48 phoenix /kernel.stable: sd1: Direct-Access 2047MB (4194058 512 byte sectors) Sep 17 19:25:48 phoenix /kernel.stable: ahc0:A:6: refuses WIDE negotiation. Using 8bit transfers Sep 17 19:25:48 phoenix /kernel.stable: scbus0 target 6 lun 0: Target Busy Sep 17 19:25:48 phoenix /kernel.stable: ahc0:A:6: refuses synchronous negotiation. Using asynchronous transfers Sep 17 19:25:48 phoenix /kernel.stable: scbus0 target 6 lun 0: Target Busy Sep 17 19:25:48 phoenix /kernel.stable: scbus0 target 6 lun 0: Target Busy Sep 17 19:25:48 phoenix /kernel.stable: st0 at scbus0 target 6 lun 0 Sep 17 19:25:48 phoenix /kernel.stable: st0: <EXABYTE EXB-8200 2618> type 1 removable SCSI 1 Sep 17 19:25:48 phoenix /kernel.stable: st0: Sequential-Access density code 0x0, Sep 17 19:25:48 phoenix /kernel.stable: st0: Target Busy Sep 17 19:25:48 phoenix /kernel.stable: Sep 17 19:25:48 phoenix /kernel.stable: st0: Target Busy Sep 17 19:25:48 phoenix /kernel.stable: Sep 17 19:25:48 phoenix /kernel.stable: st0: Target Busy Sep 17 19:25:48 phoenix /kernel.stable: drive empty Sep 17 19:25:48 phoenix /kernel.stable: ahc0: target 8 Tagged Queuing Device Sep 17 19:25:48 phoenix /kernel.stable: sd2 at scbus0 target 8 lun 0 Sep 17 19:25:48 phoenix /kernel.stable: sd2: <QUANTUM XP39100W LXY4> type 0 fixed SCSI 2 Sep 17 19:25:48 phoenix /kernel.stable: sd2: Direct-Access 8682MB (17781520 512 byte sectors) --------------------------------------------- Kernel from 98-09-18 ~17:00 CEDT Sep 18 17:41:05 phoenix /kernel: (noperiph:ahc0:0:X:X): SCSI bus reset delivered. 0 SCBs aborted. Sep 18 17:41:05 phoenix /kernel: ahc0: Selection Timeout on A:2. 1 SCBs aborted Sep 18 17:41:05 phoenix /kernel: ahc0: Selection Timeout on A:3. 1 SCBs aborted Sep 18 17:41:05 phoenix /kernel: ahc0: Selection Timeout on A:4. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:5. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:6. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:9. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:10. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:11. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:12. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:13. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:14. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: Selection Timeout on A:15. 1 SCBs aborted Sep 18 17:41:06 phoenix /kernel: ahc0: target 1 synchronous at 10.0M Sep 18 17:41:06 phoenix /kernel: Hz, offset = 0xf Sep 18 17:41:06 phoenix /kernel: ahc0: target 8 using 16bit transfers Sep 18 17:41:06 phoenix /kernel: ahc0: target 8 synchronous at 20.0MHz, offset = 0x8 Sep 18 17:41:06 phoenix /kernel: ahc0: target 0 synchronous at 10.0MHz, offset = 0xf Sep 18 17:41:06 phoenix /kernel: pass0 at ahc0 bus 0 target 0 lun 0 Sep 18 17:41:06 phoenix /kernel: pass0: <SEAGATE ST11900N 8650> Fixed Direct Access SCSI2 device Sep 18 17:41:06 phoenix /kernel: pass0: Serial Number 00765238 Sep 18 17:41:06 phoenix /kernel: pass0: 10.0MB/s transfers (10.0MHz, offset 15), Tagged Queueing Enabled Sep 18 17:41:06 phoenix /kernel: pass1 at ahc0 bus 0 target 1 lun 0 Sep 18 17:41:06 phoenix /kernel: pass1: <HP C3725S 5153> Fixed Direct Access SCSI2 device Sep 18 17:41:06 phoenix /kernel: pass1: Serial Number MY6002NMHQ Sep 18 17:41:06 phoenix /kernel: pass1: 10.0MB/s transfers (10.0MHz, offset 15) Sep 18 17:41:06 phoenix /kernel: pass2 at ahc0 bus 0 target 8 lun 0 Sep 18 17:41:06 phoenix /kernel: pass2: <QUANTUM XP39100W LXY4> Fixed Direct Access SCSI2 device Sep 18 17:41:06 phoenix /kernel: pass2: Serial Number PCB=2011300101 ; HDA=189709631865 Sep 18 17:41:06 phoenix /kernel: pass2: 40.0MB/s transfers (20.0MHz, offset 8, 16bit), Tagged Queueing Enabled Sep 18 17:41:06 phoenix /kernel: da1 at ahc0 bus 0 target 1 lun 0 Sep 18 17:41:06 phoenix /kernel: da1: <HP C3725S 5153> Fixed Direct Access SCSI2 device Sep 18 17:41:06 phoenix /kernel: da1: Serial Number MY6002NMHQ Sep 18 17:41:06 phoenix /kernel: da1: 10.0MB/s transfers (10.0MHz, offset 15) Sep 18 17:41:06 phoenix /kernel: da1: 2047MB (4194058 512 byte sectors: 64H 32S/T 2047C) Sep 18 17:41:06 phoenix /kernel: da2 at ahc0 bus 0 target 8 lun 0 Sep 18 17:41:06 phoenix /kernel: da2: Sep 18 17:41:06 phoenix /kernel: <QUANTUM XP39100W LXY4> Fixed Direct Access SCSI2 device Sep 18 17:41:06 phoenix /kernel: da2: Serial Number PCB=2011300101 ; HDA=189709631865 Sep 18 17:41:06 phoenix /kernel: da2: 40.0MB/s transfers (20.0MHz, offset 8, 16bit), Tagged Queueing Enabled Sep 18 17:41:06 phoenix /kernel: da2: 8682MB (17781520 512 byte sectors: 64H 32S/T 8682C) Sep 18 17:41:06 phoenix /kernel: da0 at ahc0 bus 0 target 0 lun 0 Sep 18 17:41:06 phoenix /kernel: da0: <SEAGATE ST11900N 8650> Fixed Direct Access SCSI2 device Sep 18 17:41:06 phoenix /kernel: da0: Serial Number 00765238 Sep 18 17:41:06 phoenix /kernel: da0: 10.0MB/s transfers (10.0MHz, offset 15), Tagged Queueing Enabled Sep 18 17:41:06 phoenix /kernel: da0: 1621MB (3320691 512 byte sectors: 64H 32S/T 1621C) Sep 18 17:41:06 phoenix /kernel: Considering FFS root f/s. ___________________________________________________________ Internet: johan@granlund.nu I don't even speak for myself To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199809181605.SAA00314>