Date: Tue, 30 Jun 2015 20:14:07 -0400 From: Kurt Lidl <lidl@pix.net> To: freebsd-stable@freebsd.org Subject: Re: New FreeBSD snapshots available: stable/10 (20150625 r284813) Message-ID: <559330CF.2050606@pix.net> In-Reply-To: <20150626174927.GA69720@FreeBSD.org> References: <20150626174927.GA69720@FreeBSD.org>
next in thread | previous in thread | raw e-mail | index | archive | help
> [-stable@ in CC since these are the first 10.2-PRERELEASE builds
> available since the code slush went into effect, which marks the start
> of the release cycle.]
>
> New FreeBSD development branch installation ISOs and virtual machine
> disk images have been uploaded to the FTP mirrors.
>
> As with any development branch, the installation snapshots are not
> intended for use on production systems. We do, however, encourage
> testing on non-production systems as much as possible.
I was able to download the sparc64 iso image, burn the iso to a
cd-rom, and boot a sparc64 V120 from that image.
I was also able to perform an install onto a ZFS only setup,
and have it work properly.
The only other testing I did was to recompile a custom kernel, and
that worked fine too. From the aspect of having a ZFS only
configuration "just work", this is by far the best that I've
seen to date.
-Kurt
dmesg follows:
Copyright (c) 1992-2015 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 10.2-PRERELEASE #1: Tue Jun 30 19:51:35 EDT 2015
root@ton.pix.net:/usr/obj/usr/src/sys/V120 sparc64
gcc version 4.2.1 20070831 patched [FreeBSD]
real memory = 4294967296 (4096 MB)
avail memory = 4175503360 (3982 MB)
cpu0: Sun Microsystems UltraSparc-IIe Processor (648.00 MHz CPU)
WARNING: VIMAGE (virtualized network stack) is a highly experimental
feature.
random: <Software, Yarrow> initialized
nexus0: <Open Firmware Nexus device>
pcib0: <U2P UPA-PCI bridge> mem
0x1fe00000000-0x1fe0000ffff,0x1fe01000000-0x1fe010000ff irq
2032,2030,2031,2021 on nexus0
pcib0: Sabre, impl 0, version 0, IGN 0x1f, bus A, 66MHz
pcib0: DVMA map: 0xc0000000 to 0xc3ffffff 8192 entries
pcib0: [GIANT-LOCKED]
pci0: <OFW PCI bus> on pcib0
pcib1: <APB PCI-PCI bridge> at device 1.1 on pci0
pci1: <OFW PCI bus> on pcib1
ebus0: <PCI-EBus3 bridge> mem
0xf0000000-0xf0ffffff,0xf1000000-0xf17fffff at device 12.0 on pci1
ebus0: <idprom>: incomplete
pcib2: <APB PCI-PCI bridge> at device 1.0 on pci0
pci2: <OFW PCI bus> on pcib2
ebus0: <flashprom> addr 0x1000000000-0x10000fffff (no driver attached)
eeprom0: <EEPROM/clock> addr 0x1400000000-0x1400001fff on ebus0
eeprom0: model mk48t59
ebus0: <SUNW,lomh> addr 0x1400200000-0x1400200003 irq 42 (no driver
attached)
pci1: <old, non-VGA display device> at device 3.0 (no driver attached)
isab0: <PCI-ISA bridge> at device 7.0 on pci1
isa0: <ISA bus> on isab0
gem0: <Sun ERI 10/100 Ethernet> mem 0xe0400000-0xe041ffff at device 12.1
on pci1
miibus0: <MII bus> on gem0
ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
ukphy0: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto,
auto-flow
gem0: 2kB RX FIFO, 2kB TX FIFO
gem0: Ethernet address: 00:03:ba:2f:fc:50
ohci0: <Sun PCIO-2 USB controller> mem 0xe2000000-0xe2007fff at device
12.3 on pci1
usbus0 on ohci0
atapci0: <AcerLabs M5229 UDMA66 controller> port
0x400-0x407,0x418-0x41b,0x410-0x417,0x408-0x40b,0x420-0x42f at device
13.0 on pci1
atapci0: using PIO transfers above 137GB as workaround for 48bit DMA
access bug, expect reduced performance
ata2: <ATA channel> at channel 0 on atapci0
ata3: <ATA channel> at channel 1 on atapci0
gem1: <Sun ERI 10/100 Ethernet> mem 0xe0440000-0xe045ffff at device 5.1
on pci1
miibus1: <MII bus> on gem1
ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
ukphy1: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto,
auto-flow
gem1: 2kB RX FIFO, 2kB TX FIFO
gem1: Ethernet address: 00:03:ba:2f:fc:51
ohci1: <Sun PCIO-2 USB controller> mem 0xe5000000-0xe5007fff at device
5.3 on pci1
usbus1 on ohci1
sym0: <896> port 0xc00000-0xc000ff mem 0x2000-0x23ff,0x4000-0x5fff at
device 8.0 on pci2
sym0: No NVRAM, ID 7, Fast-40, LVD, parity checking
sym1: <896> port 0xc00100-0xc001ff mem 0x6000-0x63ff,0x8000-0x9fff at
device 8.1 on pci2
sym1: No NVRAM, ID 7, Fast-40, LVD, parity checking
uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 43 on isa0
uart0: console (9600,n,8,1)
uart1: <16550 or compatible> at port 0x2e8-0x2ef irq 43 on isa0
usbus0: 12Mbps Full Speed USB v1.0
ZFS filesystem version: 5
ZFS storage pool version: features support (5000)
Timecounter "tick" frequency 648000000 Hz quality 1000
Event timer "tick" frequency 648000000 Hz quality 1000
Timecounters tick every 1.000 msec
usbus1: 12Mbps Full Speed USB v1.0
ugen0.1: <SUN> at usbus0
uhub0: <SUN OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus0
ugen1.1: <SUN> at usbus1
uhub1: <SUN OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus1
uhub0: 4 ports with 4 removable, self powered
uhub1: 4 ports with 4 removable, self powered
random: unblocking device.
da0 at sym0 bus 0 scbus2 target 0 lun 0
da0: <FUJITSU MAT3073NC 0108> Fixed Direct Access SCSI-3 device
da0: Serial Number AAL0P58055P6
da0: 80.000MB/s transfers (40.000MHz, offset 31, 16bit)
da0: Command Queueing enabled
da0: 70136MB (143638992 512 byte sectors: 255H 63S/T 8941C)
da1 at sym0 bus 0 scbus2 target 1 lun 0
da1: <FUJITSU MAW3073NC 0104> Fixed Direct Access SCSI-3 device
da1: Serial Number DAL0P7906GC1
da1: 80.000MB/s transfers (40.000MHz, offset 31, 16bit)
da1: Command Queueing enabled
da1: 70136MB (143638992 512 byte sectors: 255H 63S/T 8941C)
cd0 at ata2 bus 0 scbus0 target 0 lun 0
cd0: <TEAC DV-28E-B 1.2B> Removable CD-ROM SCSI device
cd0: 33.300MB/s transfers (UDMA2, ATAPI 12bytes, PIO 65534bytes)
cd0: cd present [256000 x 2048 byte records]
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?559330CF.2050606>