Date: Wed, 21 Feb 1996 19:32:35 -0700 From: Nate Williams <nate@sri.MT.net> To: Trevor Mendez <tmendez@BBN.COM> Cc: freebsd-hardware@freebsd.org Subject: Re: Net Install with 3c589 (PCMCIA) Message-ID: <199602220232.TAA16306@rocky.sri.MT.net> In-Reply-To: <199602220031.QAA13872@freefall.freebsd.org>
index | next in thread | previous in thread | raw e-mail
Trevor Mendez writes: > > * Attempting to load FreeBSD 2.1 over the Net onto a IBM ThinkPad using > a 3Com EtherLink III ethernet card (3c589). > > * Successfully made a boot disk with image from the ftp site. > > * Everything worked except that after about 20 attempts, the device is never > attached -- it is recognized as being in slot 1, but the probe to the I/O > address fails, resulting in "zp0 not found at 0x300". > > * I have used tried using 3com software to set the device's I/O port and INT# > to the ones used by the kernel. And I have set the numbers on the card and > in the kernel (booting with "-c") to several other pairs of numbers without > success. Did you run the software w/out card services running? > > Is there something else that I should try? Thanks.` What is the IOMEM set to? You can't set the IOMEM value, but you can look at what it's set to using the configuration program. Natehome | help
Want to link to this message? Use this
URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199602220232.TAA16306>