Date: Thu, 6 Aug 1998 14:03:58 -0700 (PDT) From: Doug White <dwhite@resnet.uoregon.edu> To: Mikkel Christiansen <mixxel@cs.unc.edu> Cc: freebsd-questions@FreeBSD.ORG Subject: Re: Adaptec 2940U/UW [No Driver Assigned] Message-ID: <Pine.BSF.4.00.9808061401410.28098-100000@resnet.uoregon.edu> In-Reply-To: <35C8956C.B98D67A0@cs.unc.edu>
next in thread | previous in thread | raw e-mail | index | archive | help
On Wed, 5 Aug 1998, Mikkel Christiansen wrote: > I'm trying to install FreeBSD (2.2.7 boot.flp) on a DELL pentium II with > an Adaptec 2940U/UW controler. > According to the FreeBSD handbook this controller should be supported > - but it detects that there is a device on the PCI but - but does not > assign a driver to it. The actual message is: > > pci0:14:0: Adaptec, device=0x7895, class=storage (scsi) int a irq 11 [no > driver assigned] > pci0:14:1: Adaptec, device=0x7895, class=storage (scsi) int b irq 14 [no > driver assigned] This is a 2940U2W, based on the AIC7895 chip, which is significantly different from a 2940UW, which is based on the AIC7880 chip. You'll need the patches from ftp://ftp.freebsd.org/pub/FreeBSD/cam and the boot floppies from http://www.freebsd.org/~abial/cam-boot. > Furthermore, it gives the same message about the Ethernet Card > (device=9055) which is > a 3COM 905B, which according the the FreeBSD handbook also should be > supported. The 905 yes, the 905B no. However, there is a driver you can add to the system at http://www.freebsd.org/~wpaul/3Com/. You have just too new hardware. :) Doug White | University of Oregon Internet: dwhite@resnet.uoregon.edu | Residence Networking Assistant http://gladstone.uoregon.edu/~dwhite | Computer Science Major To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.00.9808061401410.28098-100000>