Date: 02 Jul 1995 18:26:54 GMT From: djnowak@pop.com (David Nowak) To: jkh@freebsd.org Subject: Problems with Seagate Drive Message-ID: <1880948734.12176714@pop.com> Resent-Message-ID: <13031.804728772@freefall.cdrom.com>
next in thread | raw e-mail | index | archive | help
I would like to run FreeBSD on my 386 system and have been informed
that you have written a Seagate SCSI driver for FreeBSD that may be
compatible with it. I have ftped version 2.0.5 of the root.flp and
bindist of FreeBSD 2.0.5 RELEASE. Apparently Drew Eckhardt
(drew@colorado.edu) has written a Seagate ST01/Future Domain TMC-885
compatible Linux driver which I have been using with Linux for several
months now. Do you use the same driver for FreeBSD 2.0.5? If so,
why can't I use it from the boot.flp disk?
I have a Future Domain TMC-885M SCSI controller card (IRQ 5, memory
address jumper at 0xC8000 and ROM BIOS 950 AT v8.00) and a Quantum P80
hard drive. When I start up from the boot disk to install FreeBSD 2.0.5,
the PARTITION submenu item of the INSTALL menu does not recognize my FD
card. When I rebooted my system and type "-c" to enter the userconfig
mode, and type in "probe SEA0" I get the following error messages:
Fatal trap 12: page fault while in kernal mode
fault virtual address = 0x0
fault code = supervisor read, page not present
instruction pointer = 0x8:0f01130f6
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def 32 1, gran 1
processor eflags = resume, IOPL = 0
current process = 0 ()
interrupt mask = net tty bio
panic: page fault
hit reset please
Jordan,
Do you have any workarounds for me to get past this roadblock?
Any suggestions would be appreciated. Thanks.
David Nowak
djnowak@pop.com
--
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?1880948734.12176714>