Date: Sat, 21 Mar 2009 22:40:12 +0100 From: Andreas Tobler <andreast-list@fgznet.ch> To: freebsd-sparc64@freebsd.org, freebsd-current <freebsd-current@freebsd.org> Subject: kdb enter when upgrading from 7.1 to current. Message-ID: <49C55EBC.1070602@fgznet.ch>
next in thread | raw e-mail | index | archive | help
Hi,
I get this stacktrace when I try to boot from a Kernel as of today (svn:
190217).
My setup is a 7.1 install where I'd like to upgrade to current.
The kernel is built cross, amd64 -> sparc64:
make -j4 buildkernel TARGET_ARCH=sparc64 KERNCONF=GENERIC
The target machine itself is a u60, details below.
Does anyone have a pointer to help me, would be great!
TIA,
Andreas
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [/boot/kernel/kernel]...
jumping to kernel entry at 0xc0080000.
GDB: no debug ports present
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2009 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 8.0-CURRENT #2 r190217M: Sat Mar 21 22:27:46 CET 2009
andreast@deuterium_fbsd.andreas.nets:/export/devel/obj/sparc64/export/devel/
fbsd_svn/src/sys/GENERIC
WARNING: WITNESS option enabled, expect reduced performance.
real memory = 1610612736 (1536 MB)
avail memory = 1554710528 (1482 MB)
cpu0: Sun Microsystems UltraSparc-II Processor (449.99 MHz CPU)
ispfw: registered firmware <isp_1000>
ispfw: registered firmware <isp_1040>
ispfw: registered firmware <isp_1040_it>
ispfw: registered firmware <isp_1080>
ispfw: registered firmware <isp_1080_it>
ispfw: registered firmware <isp_12160>
ispfw: registered firmware <isp_12160_it>
ispfw: registered firmware <isp_2100>
ispfw: registered firmware <isp_2200>
ispfw: registered firmware <isp_2300>
ispfw: registered firmware <isp_2322>
ispfw: registered firmware <isp_2400>
kbd0 at kbdmux0
nexus0: <Open Firmware Nexus device>
pcib0: <U2P UPA-PCI bridge> mem
0x1fe00004000-0x1fe00005fff,0x1fe01000000-0x1fe0
10000ff,0x1fe00000000-0x1fe0000cfff irq 2033,2030,2031,2021,2024,2034 on
nexus0
pcib0: Psycho, impl 0, version 4, IGN 0x1f, bus B, 33MHz
initializing counter-timer
Timecounter "pcib0" frequency 1000000 Hz quality 100
pcib0: DVMA map: 0xfc000000 to 0xffffffff, streaming buffer
pcib0: [FILTER]
pcib0: [FILTER]
pcib0: [GIANT-LOCKED]
pcib0: [ITHREAD]
pcib0: [GIANT-LOCKED]
pcib0: [ITHREAD]
pcib0: [FILTER]
pci0: <OFW PCI bus> on pcib0
ebus0: <PCI-EBus2 bridge> mem
0x70000000-0x70ffffff,0x71000000-0x717fffff at dev
ice 1.0 on pci0
auxio0: <Sun Auxiliary I/O> addr
0x1400726000-0x1400726003,0x1400728000-0x140072
8003,0x140072a000-0x140072a003,0x140072c000-0x140072c003,0x140072f000-0x140072f0
03 on ebus0
ebus0: <power> addr 0x1400724000-0x1400724003 (no driver attached)
ebus0: <SUNW,pll> addr 0x1400504000-0x1400504002 (no driver attached)
ebus0: <sc> addr 0x1400500000-0x1400500007 (no driver attached)
scc0: <Siemens SAB 82532 dual channel SCC> addr
0x1400400000-0x140040007f irq 43
on ebus0
scc0: [FILTER]
uart0: <SAB 82532 v3.2, channel A> on scc0
uart0: [FILTER]
uart0: CTS oflow
uart0: console (9600,n,8,1)
uart1: <SAB 82532 v3.2, channel B> on scc0
uart1: [FILTER]
uart1: CTS oflow
uart2: <16550 or compatible> addr 0x14003083f8-0x14003083ff irq 41 on ebus0
uart2: [FILTER]
uart2: keyboard (1200,n,8,1)
uart2: keyboard not present
uart3: <16550 or compatible> addr 0x14003062f8-0x14003062ff irq 42 on ebus0
uart3: [FILTER]
ebus0: <ecpp> addr
0x14003043bc-0x14003043cb,0x1400300398-0x1400300399,0x1400700
000-0x140070000f irq 34 (no driver attached)
ebus0: <fdthree> addr
0x14003023f0-0x14003023f7,0x1400706000-0x140070600f,0x1400
720000-0x1400720003 irq 39 (no driver attached)
eeprom0: <EEPROM/clock> addr 0x1400000000-0x1400001fff on ebus0
eeprom0: model mk48t59
ebus0: <flashprom> addr 0x1000000000-0x10000fffff (no driver attached)
ebus0: <SUNW,CS4231> addr
0x1400200000-0x14002000ff,0x1400702000-0x140070200f,0x
1400704000-0x140070400f,0x1400722000-0x1400722003 irq 35,36 (no driver
attached)
hme0: <Sun HME 10/100 Ethernet> mem 0x100000-0x107fff at device 1.1 on pci0
miibus0: <MII bus> on hme0
qsphy0: <QS6612 10/100 media interface> PHY 1 on miibus0
qsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme0: Ethernet address: 08:00:20:a3:71:69
hme0: [ITHREAD]
sym0: <875> port 0x1000-0x10ff mem 0x108000-0x1080ff,0x10a000-0x10afff
at device
3.0 on pci0
sym0: No NVRAM, ID 7, Fast-20, SE, parity checking
sym0: [ITHREAD]
sym1: <875> port 0x1400-0x14ff mem 0x10c000-0x10c0ff,0x10e000-0x10efff
at device
3.1 on pci0
sym1: No NVRAM, ID 7, Fast-20, SE, parity checking
sym1: [ITHREAD]
pcib1: <U2P UPA-PCI bridge> mem
0x1fe00002000-0x1fe00003fff,0x1fe01800000-0x1fe0
18000ff,0x1fe00000000-0x1fe0000cfff irq 2032,2030,2031,2021,2024,2034 on
nexus0
pcib1: Psycho, impl 0, version 4, IGN 0x1f, bus A, 66MHz
pcib1: [FILTER]
pci1: <OFW PCI bus> on pcib1
pci1: <bridge> at device 1.0 (no driver attached)
creator0: <Creator3D> mem
0x1fc00000000-0x1fc000003ff,0x1fc00400000-0x1fc005ffff
f,0x1fc00600000-0x1fc007fffff,0x1fc01000000-0x1fc013fffff,0x1fc01400000-0x1fc017
fffff,0x1fc01800000-0x1fc01bfffff,0x1fc01c00000-0x1fc01ffffff,0x1fc02000000-0x1f
c02ffffff,0x1fc03000000-0x1fc03ffffff,0x1fc04000000-0x1fc043fffff,0x1fc04400000-
0x1fc047fffff,0x1fc04800000-0x1fc04bfffff,0x1fc04c00000-0x1fc04ffffff,0x1fc05000
000-0x1fc05ffffff,0x1fc06000000-0x1fc07ffffff,0x1fc09000000-0x1fc097fffff,0x1fc0
9800000-0x1fc09ffffff,0x1fc0a000000-0x1fc0affffff,0x1fc0b000000-0x1fc0b7fffff,0x
1fc0b800000-0x1fc0bffffff,0x1fc0c000000-0x1fc0c3fffff,0x1fc0c800000-0x1fc0cfffff
f,0x1fc0d000000-0x1fc0d7fffff,0x1fc0d800000-0x1fc0dffffff irq 1925 on nexus0
creator0: resolution 1152x900
syscons0: <System console> on nexus0
syscons0: Unknown <16 virtual consoles, flags=0x100>
Timecounter "tick" frequency 449992390 Hz quality 1000
Timecounters tick every 1.000 msec
Waiting 5 seconds for SCSI devices to settle
(probe6:sym0:0:6:0): TEST UNIT READY. CDB: 0 0 0 0 0 0
(probe6:sym0:0:6:0): CAM Status: SCSI Status Error
(probe6:sym0:0:6:0): SCSI Status: Check Condition
(probe6:sym0:0:6:0): NOT READY asc:3a,0
(probe6:sym0:0:6:0): Medium not present
(probe6:sym0:0:6:0): Unretryable error
da1 at sym0 bus 0 target 1 lun 0
da1: <SEAGATE ST39102LCSUN9.0G 0828> Fixed Direct Access SCSI-2 device
da1: 40.000MB/s transfers (20.000MHz, offset 15, 16bit)
da1: Command Queueing Enabled
da1: 8637MB (17689267 512 byte sectors: 255H 63S/T 1101C)
da0 at sym0 bus 0 target 0 lun 0
da0: <SEAGATE ST39102LCSUN9.0G 0828> Fixed Direct Access SCSI-2 device
da0: 40.000MB/s transfers (20.000MHz, offset 15, 16bit)
da0: Command Queueing Enabled
da0: 8637MB (17689267 512 byte sectors: 255H 63S/T 1101C)
cd0 at sym0 bus 0 target 6 lun 0
cd0: <TOSHIBA XM6201TASUN32XCD 1103> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 16)
cd0: Attempt to query device size failed: NOT READY, Medium not present
WARNING: WITNESS option enabled, expect reduced performance.
GEOM: da0: adding VTOC8 information.
GEOM: da1: adding VTOC8 information.
Trying to mount root from ufs:/dev/da0a
Loading configuration files.
kernel dumps on /dev/da0b
Entropy harvesting: interrupts ethernet point_to_pointpanic: trap:
memory addres
s not aligned
cpuid = 0
KDB: enter: panic
[thread pid 41 tid 100042 ]
Stopped at kdb_enter+0x80: ta %xcc, 1
db>
db> bt
Tracing pid 41 tid 100042 td 0xfffff800213dc370
panic() at panic+0x20c
trap() at trap+0x570
-- memory address not aligned sfar=0xf2fe2877 sfsr=0x40029 %o7=0xc06654b8 --
stack_capture() at stack_capture+0x114
stack_save_td() at stack_save_td+0x60
sysctl_kern_proc_kstack() at sysctl_kern_proc_kstack+0x36c
sysctl_root() at sysctl_root+0x1ec
userland_sysctl() at userland_sysctl+0x174
__sysctl() at __sysctl+0x70
syscall() at syscall+0x2f0
-- syscall (202, FreeBSD ELF64, __sysctl) %o7=0x101628 --
userland() at 0x40445788
user trace: trap %o7=0x101628
pc 0x40445788, sp 0x7fdffffd031
pc 0x101ef8, sp 0x7fdffffd971
pc 0x102ac4, sp 0x7fdffffdaf1
pc 0x100ef0, sp 0x7fdffffe451
pc 0x40208094, sp 0x7fdffffe511
done
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?49C55EBC.1070602>