Date: Mon, 19 Jul 1999 05:11:47 PDT From: "Freedom Bert" <freenerd@hotmail.com> To: scsi@freebsd.org Subject: Proliant 400 and Vikings II doing only 40MB/s Message-ID: <19990719121148.63023.qmail@hotmail.com>
next in thread | raw e-mail | index | archive | help
I risked making a fool of myself, but I really have to ask this. I recently installed 3.2-stable on a brand new Compaq Proliant 400. It came with a built-in onboard SCSI, an Integrated Single Channel Wide-Ultra2 SCSI controller ( really a Symbios 53c895 ) I have a Vikings II 9.1s connected to this controller. All the default settings has been turned OFF, ie. ID=0, TP is OFF, SE is OFF. The SCSI cable is the same that came with the server, it has a terminator attached to the end. I think it is a correct cable. I know I have to make sure that I'm using LVD, but I have no idea how to configure it. That's no configuration program from the SCSI controller at all. I am expecting a 80MB/s trasnfer rate which I am not gettings, and I have run out of ideas/ things to try. Perhaps some kind soul who have knwoledge of similar setup can throw me some rope here. TIA. the relevant dmesg output follows: >ncr0: <ncr 53c895 fast40 wide scsi> rev 0x02 int a irq 11 on pci2.4.0 >da0 at ncr0 bus 0 target 0 lun 0 >da0: <QUANTUM VIKING II 9.1WLS 5520> Fixed Direct Access SCSI-2 device >da0: 40.000MB/s transfers ( 20.000MHz, offset 31, 16bit), Tagged Queueing >Enabled >da0: 8709MB (17836668 512 byte sectors: 255H 63S/T 1110C) ______________________________________________________ Get Your Private, Free Email at http://www.hotmail.com To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-scsi" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?19990719121148.63023.qmail>