Date: Thu, 29 Aug 2002 16:07:55 -0500 (CDT) From: Mario Doria <madd@tecdigital.net> To: FreeBSD-gnats-submit@FreeBSD.org Subject: i386/42173: Sony VAIO FXA 53 (or FXA 679 in Mexico) won't cold boot. Message-ID: <20020829210755.361A51F@bender.tecdigital.net>
next in thread | raw e-mail | index | archive | help
>Number: 42173
>Category: i386
>Synopsis: Sony VAIO FXA 53 (or FXA 679 in Mexico) won't cold boot.
>Confidential: no
>Severity: critical
>Priority: high
>Responsible: freebsd-bugs
>State: open
>Quarter:
>Keywords:
>Date-Required:
>Class: sw-bug
>Submitter-Id: current-users
>Arrival-Date: Thu Aug 29 14:20:01 PDT 2002
>Closed-Date:
>Last-Modified:
>Originator: Mario A. Doria
>Release: FreeBSD 4.6-STABLE i386
>Organization:
>Environment:
System: FreeBSD wark 4.6-STABLE FreeBSD 4.6-STABLE #0: Thu Aug 29 02:49:13 CDT 2002 root@wark:/usr/obj/usr/src/sys/WARK i386
CVSUPed on August 29,2002 @ 01:00 CDT
>Description:
The machine will freeze when booting FreeBSD 4-STABLE if it has just
been turned on. It freezes when detecting the parallel port.
If I boot Windows XP (or 2000) and then warm boot the machine,
FreeBSD boots just fine. I tested this machine with 5-CURRENT and
there was no problem at all.
>How-To-Repeat:
Cold boot the machine.
>Fix:
Attached in /var/run/dmesg.boot
--- dmesg.boot begins here ---
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.6-STABLE #0: Thu Aug 29 02:49:13 CDT 2002
root@wark:/usr/obj/usr/src/sys/WARK
Timecounter "i8254" frequency 1193182 Hz
CPU: mobile AMD Athlon(tm) XP 1500+ (1300.06-MHz 686-class CPU)
Origin = "AuthenticAMD" Id = 0x680 Stepping = 0
Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
AMD Features=0xc0480000<<b19>,AMIE,DSP,3DNow!>
real memory = 536870912 (524288K bytes)
avail memory = 518328320 (506180K bytes)
Preloaded elf kernel "kernel" at 0xc03e6000.
netsmb_dev: loaded
Pentium Pro MTRR support enabled
md0: Malloc disk
Using $PIR table, 6 entries at 0xc00fdf60
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <VIA 8363 (Apollo KT133) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <ATI Mobility-1 graphics accelerator> at 0.0 irq 5
isab0: <VIA 82C686 PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <VIA 82C686 ATA100 controller> port 0x1c40-0x1c4f at device 7.1 on pci0
atapci0: Correcting VIA config for southbridge data corruption bug
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <VIA 83C572 USB controller> port 0x1c00-0x1c1f irq 9 at device 7.2 on pci0
usb0: <VIA 83C572 USB controller> on uhci0
usb0: USB revision 1.0
uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1: <VIA 83C572 USB controller> port 0x1c20-0x1c3f irq 9 at device 7.3 on pci0
usb1: <VIA 83C572 USB controller> on uhci1
usb1: USB revision 1.0
uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
viapropm0: SMBus I/O base at 0x8100
viapropm0: <VIA VT82C686A Power Management Unit> port 0x8100-0x810f at device 7.4 on pci0
viapropm0: SMBus revision code 0x40
smb0: <SMBus general purpose I/O> on smbus0
pcm0: <VIA VT82C686A> port 0x1c50-0x1c53,0x1c54-0x1c57,0x1000-0x10ff irq 5 at device 7.5 on pci0
chip1: <VIA 82C686 AC97 Modem> port 0x1400-0x14ff irq 5 at device 7.6 on pci0
pcic0: <TI PCI-1420 PCI-CardBus Bridge> irq 9 at device 10.0 on pci0
pcic0: PCI Memory allocated: 0x88000000
pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][FUNC pci int + CSC serial isa irq]
pccard0: <PC Card bus (classic)> on pcic0
pcic1: <TI PCI-1420 PCI-CardBus Bridge> irq 10 at device 10.1 on pci0
pcic1: PCI Memory allocated: 0x88001000
pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][FUNC pci int + CSC serial isa irq]
pccard1: <PC Card bus (classic)> on pcic1
pci0: <unknown card> (vendor=0x104c, dev=0x8020) at 14.0 irq 9
rl0: <RealTek 8139 10/100BaseTX> port 0x1800-0x18ff mem 0xe8004800-0xe80048ff irq 10 at device 16.0 on pci0
rl0: Ethernet address: 08:00:46:6e:58:6e
miibus0: <MII bus> on rl0
rlphy0: <RealTek internal media interface> on miibus0
rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
orm0: <Option ROMs> at iomem 0xc0000-0xcffff,0xd0000-0xd3fff,0xdc000-0xdffff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model GlidePoint, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
< machine freezes here >
IP Filter: v3.4.27 initialized. Default = pass all, Logging = disabled
ata1-slave: ATAPI identify retries exceeded
ad0: 28615MB <HITACHI_DK23DA-30> [58140/16/63] at ata0-master UDMA100
acd0: CD-RW <UJDA720 DVD/CDRW> at ata1-master PIO4
Mounting root from ufs:/dev/ad0s3a
--- dmesg.boot ends here ---
>Release-Note:
>Audit-Trail:
>Unformatted:
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-bugs" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20020829210755.361A51F>