Date: Wed, 2 Aug 1995 17:13:03 +0200 (MET DST) From: Udo Wolter <uwp@cs.tu-berlin.de> To: questions@freebsd.org (freebsd) Subject: Switches/Jumpers on a NE2000 clone ? Message-ID: <199508021513.RAA03066@blasuarr.cs.tu-berlin.de>
next in thread | raw e-mail | index | archive | help
Hi !
I bought a cheap NE2000 clone (8bit card) without documentation and software.
Now I want to know, how the bar with the switches must be configured and
how to configure the 4 bars with the jumpers. 2 Jumper bars are for
DMA/IRQ (both 8 jumpers). But the rest ?
Also, I never installed such a card. The manual told me that I have
to configure the card as ed0. ed1 would be another card ?
What else I have to do ? ifconfig ? arp ?
By the way, I want to make my own terminators, can anybody help me with
the specifications of a BNC-ether-terminator ? How many ohms ?
Thanx a lot !
Bye,
Udo
P.S.: I only found ONE newsgroup in the USENET (comp.dcom.lans.ethernet), is
there anything similar in german ? Because there came nothing back,
I tried it here. I hope you're not too angry about it. :-)
--
Udo Wolter, email: uwp@cs.tu-berlin.de & uwp@hydmech.fb12.tu-berlin.de,
www: http://www.cs.tu-berlin.de/~uwp/
!!! NEW: LOW-TECH Page: http://www.cs.tu-berlin.de/~uwp/low-tech.html !!!
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199508021513.RAA03066>