Date: Fri, 26 Oct 2001 16:55:37 -0600 From: Scott Long <scott_long@btc.adaptec.com> To: rrios@intersys.com.mx Cc: hodson@aciri.org, freebsd-multimedia@freebsd.org Subject: Re: " ESS Maestro PCI Audio (WDM) supported?? " Message-ID: <20011026165537.G2044@hollin.btc.adaptec.com> In-Reply-To: <06256AF1.007DE984.00@smgwisys.intersys.com.mx> References: <06256AF1.007DE984.00@smgwisys.intersys.com.mx>
next in thread | previous in thread | raw e-mail | index | archive | help
You are using a Maestro3. There are GPL restrictions on the driver that preclude us from making it available in the default GENERIC kernel. To load it you can either type 'kldload snd_maestro3' after you boot, or add the following line to /boot/loader.conf: snd_maestro3_load="YES" Scott On Fri, Oct 26, 2001 at 04:48:36PM -0600, rrios@intersys.com.mx wrote: > > > > this is my dmesg > > Copyright (c) 1992-2001 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > The Regents of the University of California. All rights reserved. > FreeBSD 4.4-RELEASE #8: Fri Oct 26 16:28:36 GMT 2001 > root@rrios.intersys.com.mx:/usr/src/sys/compile/INTERSYS > Timecounter "i8254" frequency 1193182 Hz > CPU: Pentium III/Pentium III Xeon/Celeron (697.86-MHz 686-class CPU) > Origin = "GenuineIntel" Id = 0x686 Stepping = 6 > > Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE> > real memory = 134135808 (130992K bytes) > config> di sn0 > config> di lnc0 > config> di ie0 > config> di fe0 > config> di ed0 > config> di cs0 > config> di bt0 > No such device: bt0 > Invalid command or syntax. Type `?' for help. > config> di ata1 > config> di aic0 > No such device: aic0 > Invalid command or syntax. Type `?' for help. > config> di aha0 > No such device: aha0 > Invalid command or syntax. Type `?' for help. > config> di adv0 > No such device: adv0 > Invalid command or syntax. Type `?' for help. > config> q > avail memory = 125763584 (122816K bytes) > Preloaded elf kernel "kernel" at 0xc04ba000. > Preloaded userconfig_script "/boot/kernel.conf" at 0xc04ba09c. > Pentium Pro MTRR support enabled > md0: Malloc disk > Using $PIR table, 9 entries at 0xc00fbd80 > npx0: <math processor> on motherboard > npx0: INT 16 interface > pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard > pci0: <PCI bus> on pcib0 > pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0 > pci1: <PCI bus> on pcib1 > pci1: <ATI model 4c46 graphics accelerator> at 0.0 irq 11 > pcic0: <TI PCI-1420 PCI-CardBus Bridge> irq 11 at device 3.0 on pci0 > pcic0: PCI Memory allocated: 0x44000000 > pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][FUNC pci int + CSC > serial isa irq] > pccard0: <PC Card bus (classic)> on pcic0 > pcic1: <TI PCI-1420 PCI-CardBus Bridge> irq 11 at device 3.1 on pci0 > pcic1: PCI Memory allocated: 0x44001000 > pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][FUNC pci int + CSC > serial isa irq] > pccard1: <PC Card bus (classic)> on pcic1 > isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0 > isa0: <ISA bus> on isab0 > atapci0: <Intel PIIX4 ATA33 controller> port 0x860-0x86f at device 7.1 on pci0 > ata0: at 0x1f0 irq 14 on atapci0 > ata1: at 0x170 irq 15 on atapci0 > pci0: <Intel 82371AB/EB (PIIX4) USB controller> at 7.2 irq 11 > chip1: <Intel 82371AB Power management controller> port 0x840-0x84f at device > 7.3 on pci0 > pci0: <unknown card> (vendor=0x125d, dev=0x1998) at 8.0 irq 5 > xl0: <3Com 3c556 Fast Etherlink XL> port 0xd400-0xd4ff mem > 0xfbffd800-0xfbffd87f,0xfbffdc00-0xfbffdc7f irq 11 at device 16.0 on pci0 > xl0: Ethernet address: 00:00:86:4f:e1:5f > miibus0: <MII bus> on xl0 > ukphy0: <Generic IEEE 802.3u media interface> on miibus0 > ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto > pci0: <unknown card> (vendor=0x10b7, dev=0x1007) at 16.1 irq 11 > orm0: <Option ROMs> at iomem > 0xc0000-0xcffff,0xd0000-0xd07ff,0xd0800-0xd0fff,0xd1000-0xd17ff,0xd1800-0xd1fff,0xd2000-0xd27ff,0xd2800-0xd2fff,0xd3000-0xd37ff > > on isa0 > fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 > fdc0: FIFO enabled, 8 bytes threshold > fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 > atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 > kbd0 at atkbd0 > psm0: <PS/2 Mouse> irq 12 on atkbdc0 > psm0: model IntelliMouse, device ID 3 > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 > sc0: <System console> at flags 0x100 on isa0 > sc0: VGA <16 virtual consoles, flags=0x300> > sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 > sio0: type 16550A > sio1: configured irq 3 not in bitmap of probed irqs 0 > ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 > ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode > ppc0: FIFO with 16/16/8 bytes threshold > plip0: <PLIP network interface> on ppbus0 > lpt0: <Printer> on ppbus0 > lpt0: Interrupt-driven port > ppi0: <Parallel I/O> on ppbus0 > DUMMYNET initialized (010124) > IP packet filtering initialized, divert enabled, rule-based forwarding enabled, > default to deny, logging limited to 10 packets/entry by default > BRIDGE 010131, have 7 interfaces > -- index 1 type 6 phy 0 addrl 6 addr 00.00.86.4f.e1.5f > IPsec: Initialized Security Association Processing. > IP Filter: v3.4.20 initialized. Default = pass all, Logging = enabled > ad0: 5729MB <IBM-DJSA-210> [12416/15/63] at ata0-master UDMA33 > acd0: CDROM <SAMSUNG CD-ROM SN-124> at ata1-master using PIO4 > Mounting root from ufs:/dev/ad0s2a > > and my kernel line > > device pcm0 > > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-multimedia" in the body of the message To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-multimedia" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20011026165537.G2044>