Date: Tue, 21 Mar 2006 10:24:55 -0500 (EST) From: jason kawaja <kawaja@ece.ufl.edu> To: freebsd-scsi@freebsd.org Subject: Re: qlogic isp 6312 device not showing up Message-ID: <Pine.BSF.4.62.0603211022260.17308@felix.ece.ufl.edu> In-Reply-To: <Pine.BSF.4.62.0603210924180.17308@felix.ece.ufl.edu> References: <Pine.BSF.4.62.0603210739370.17308@felix.ece.ufl.edu> <44200030.9090400@centtech.com> <Pine.BSF.4.62.0603210924180.17308@felix.ece.ufl.edu>
next in thread | previous in thread | raw e-mail | index | archive | help
On Tue, 21 Mar 2006, jason kawaja wrote: > On Tue, 21 Mar 2006, Eric Anderson wrote: > >> jason kawaja wrote: >>> ibm xseries 346, dual xeon dual core with qlogic fc card. >>> >>> external disk device shows up within the qlogic bios (once wwid is >>> correctly added to the disk array manager,ibm shark) however does not show >>> from within freebsd. any ideas? information below. thank you. >>> >>> isp0: <Qlogic ISP 6312 PCI FC-AL Adapter> port 0x4000-0x40ff mem >>> 0xdefff000-0xdeffffff irq 96 at device 4.0 on pci4 >>> isp0: [GIANT-LOCKED] >>> isp0: bad hard address 125- resetting to zero >> >> I'm guessing the "bad hard address 125" is the problem. Sounds like you >> manually set a hard address in the BIOS - is that necessary for your >> configuration? > > it is not set manually, defaults are set. is 125- a truncated number? > could a malformatted partition (on the fc disk device) cause this > behavior? i am able to produce scsi errors from within the qlogic bios disk utility, will focus my attention there for now. thanks. -- Jason Kawaja 2-4568 http://www.ietf.org/rfc/rfc1855.txt
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.62.0603211022260.17308>