In-Reply-To: <bug-280074-7501@https.bugs.freebsd.org/bugzilla/>
index | | previous in thread | raw e-mail
https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=280074 --- Comment #22 from Joshua Kinard <freebsd@kumba.dev> --- dmesg output, same as before. I am rebooting the machine after each test so that the dmesg output stays consistent: > # dmesg | grep "em0\|epair0\|jail0\|bridge0\|lo0" > em0: <Intel(R) I219-V CNP(6)> mem 0x91b00000-0x91b1ffff at device 31.6 on pci0 > em0: EEPROM V0.4-4 > em0: Using 4096 TX descriptors and 4096 RX descriptors > em0: Using an MSI interrupt > em0: Ethernet address: aa:bb:cc:dd:ee:ff > [9] bridge0: Ethernet address: aa:bb:cc:dd:ee:ff > [10] em0: link state changed to UP > [10] lo0: link state changed to UP > [20] em0: link state changed to DOWN > [20] em0: link state changed to UP > [32] em0: link state changed to DOWN > [32] em0: link state changed to UP > [40] bridge0: WARNING: Adding member interface em0 which has an IP address assigned is deprecated and will be unsupported in a future release. > [51] em0: promiscuous mode enabled > [51] em0: link state changed to DOWN > [51] bridge0: link state changed to UP > [51] em0: link state changed to UP > [54] epair0a: Ethernet address: aa:bb:cc:dd:ee:ff > [54] epair0b: Ethernet address: aa:bb:cc:dd:ee:ff > [54] epair0a: link state changed to UP > [54] epair0b: link state changed to UP > [64] epair0a: promiscuous mode enabled > [65] em0: link state changed to DOWN > [65] em0: link state changed to UP > [66] epair0b: changing name to 'jail0' > [66] lo0: link state changed to UP > [278] epair0a: promiscuous mode disabled > [279] em0: 2 link states coalesced > [279] em0: link state changed to UP > [279] epair0a: link state changed to DOWN > [279] jail0: link state changed to DOWN ifconfig while jail is running. As requested, all of the interface capabilities are enabled, some data masked: > em0: flags=1008943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 9000 > options=e500bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,VLAN_HWFILTER,VLAN_HWTSO,RXCSUM_IPV6,TXCSUM_IPV6,HWSTATS> > ether aa:bb:cc:dd:ee:ff > inet x.x.x.x netmask 0xffffff00 broadcast x.x.x.255 > inet6 fe80::xxxx:xxxx:xxxx:xxxx%em0 prefixlen 64 scopeid 0x1 > inet6 fdxx:xxxx:xxxx:xxxx::xxxx:xxxx prefixlen 120 > media: Ethernet autoselect (1000baseT <full-duplex>) > status: active > nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL> > lo0: flags=1008049<UP,LOOPBACK,RUNNING,MULTICAST,LOWER_UP> metric 0 mtu 16384 > options=680003<RXCSUM,TXCSUM,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6> > inet 127.0.0.1 netmask 0xff000000 > inet6 ::1 prefixlen 128 > inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2 > groups: lo > nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL> > bridge0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 9000 > options=10<VLAN_HWTAGGING> > ether aa:bb:cc:dd:ee:ff > id xx:xx:xx:xx:xx:xx priority 32768 hellotime 2 fwddelay 15 > maxage 20 holdcnt 6 proto rstp maxaddr 2000 timeout 1200 > root id 00:e0:67:22:31:d6 priority 32768 ifcost 70000 port 1 > bridge flags=0<> > member: epair0a flags=1c7<LEARNING,DISCOVER,STP,AUTOEDGE,PTP,AUTOPTP> > port 5 priority 128 path cost 2000 proto rstp > role designated state forwarding vlan protocol 802.1q > member: em0 flags=1c7<LEARNING,DISCOVER,STP,AUTOEDGE,PTP,AUTOPTP> > port 1 priority 128 path cost 20000 proto rstp > role root state forwarding vlan protocol 802.1q > groups: bridge > nd6 options=9<PERFORMNUD,IFDISABLED> > ipfw0: flags=1008801<UP,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 65536 > options=0 > groups: ipfw > epair0a: flags=1008943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 9000 > options=60000b<RXCSUM,TXCSUM,VLAN_MTU,RXCSUM_IPV6,TXCSUM_IPV6> > ether aa:bb:cc:dd:ee:ff > groups: epair > media: Ethernet 10Gbase-T (10Gbase-T <full-duplex>) > status: active > nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> ifconfig after jail shutdown: > em0: flags=1008943<UP,BROADCAST,RUNNING,PROMISC,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 9000 > options=4e500bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,VLAN_HWFILTER,VLAN_HWTSO,RXCSUM_IPV6,TXCSUM_IPV6,HWSTATS,MEXTPG> > ether aa:bb:cc:dd:ee:ff > inet x.x.x.x netmask 0xffffff00 broadcast x.x.x.255 > inet6 fe80::xxxx:xxxx:xxxx:xxxx%em0 prefixlen 64 scopeid 0x1 > inet6 fdxx:xxxx:xxxx:xxxx::xxxx:xxxx prefixlen 120 > media: Ethernet autoselect (1000baseT <full-duplex>) > status: active > nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL> > lo0: flags=1008049<UP,LOOPBACK,RUNNING,MULTICAST,LOWER_UP> metric 0 mtu 16384 > options=680003<RXCSUM,TXCSUM,LINKSTATE,RXCSUM_IPV6,TXCSUM_IPV6> > inet 127.0.0.1 netmask 0xff000000 > inet6 ::1 prefixlen 128 > inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2 > groups: lo > nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL> > bridge0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 9000 > options=10<VLAN_HWTAGGING> > ether aa:bb:cc:dd:ee:ff > id xx:xx:xx:xx:xx:xx priority 32768 hellotime 2 fwddelay 15 > maxage 20 holdcnt 6 proto rstp maxaddr 2000 timeout 1200 > root id 00:e0:67:22:31:d6 priority 32768 ifcost 70000 port 1 > bridge flags=0<> > member: em0 flags=1c7<LEARNING,DISCOVER,STP,AUTOEDGE,PTP,AUTOPTP> > port 1 priority 128 path cost 20000 proto rstp > role root state forwarding vlan protocol 802.1q > groups: bridge > nd6 options=9<PERFORMNUD,IFDISABLED> > ipfw0: flags=1008801<UP,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 65536 > options=0 > groups: ipfw -- You are receiving this mail because: You are the assignee for the bug.home | help