Date: Tue, 9 Jan 2001 11:38:23 -0500 From: Vivek Khera <khera@kciLink.com> To: freebsd-stable@FreeBSD.ORG Subject: Re: Intel PRO/100+ driver or hardware? Message-ID: <14939.15999.339574.284445@onceler.kciLink.com> In-Reply-To: <200101082356.QAA01425@freeway.dcfinc.com> References: <Pine.BSF.4.31.0101081207360.72666-100000@localhost> <200101082356.QAA01425@freeway.dcfinc.com>
next in thread | previous in thread | raw e-mail | index | archive | help
>>>>> "CRL" == Chad R Larson <chad@DCFinc.com> writes:
CRL> | chad> ifconfig fxp0
CRL> | fxp0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
CRL> | inet 192.168.1.129 netmask 0xffffff00 broadcast 192.168.1.255
CRL> | ether 00:a0:c9:49:ec:ca
CRL> | media: autoselect
CRL> | supported media: autoselect 100baseTX <full-duplex> 100baseTX 10baseT/UTP <full-duplex> 10baseT/UTP
CRL> +---------------
CRL> How can I tell if this interface is running 100/full or 10/half?
It isn't connected. Note the "media" line as compared to the output
of mine:
[onceler]% ifconfig fxp0
fxp0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet 208.184.13.196 netmask 0xffffff00 broadcast 208.184.13.255
ether 00:e0:18:ac:14:21
media: autoselect (100baseTX <full-duplex>) status: active
supported media: autoselect 100baseTX <full-duplex> 100baseTX 10baseT/UTP <full-duplex> 10baseT/UTP
Is the link light on the card on or off? There should also be a
10/100 light that is on for 100baseT (full or half).
--
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Vivek Khera, Ph.D. Khera Communications, Inc.
Internet: khera@kciLink.com Rockville, MD +1-240-453-8497
AIM: vivekkhera Y!: vivek_khera http://www.khera.org/~vivek/
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?14939.15999.339574.284445>