Date: Mon, 28 Feb 2000 08:48:13 -0800 (PST) From: Brian Beattie <beattie@aracnet.com> To: freebsd-current@freebsd.org Subject: panics and hangs under 4.0-current Message-ID: <Pine.LNX.4.21.0002280835360.3617-100000@shell1.aracnet.com>
next in thread | raw e-mail | index | archive | help
I have gotten several panics while doing a "make release". I have not been able to get a dump, (not configure correctly or the kernel was too scrod). I have put two console logs up on my web server: http:/www.aracnet.com/~beattie/FreeBSD If anybody cares to look, The last panic appears to really leave things is a bad state, the console log is below. I'll try to do a build world tonoight. Copyright (c) 1992-2000 The FreeBSD Project. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. FreeBSD 4.0-CURRENT #14: Thu Feb 24 02:05:29 PST 2000 beattie@raven.beattie-home.net:/usr/src/sys/compile/RAVEN Timecounter "i8254" frequency 1193182 Hz CPU: AMD-K6(tm) 3D processor (332.90-MHz 586-class CPU) Origin = "AuthenticAMD" Id = 0x58c Stepping = 12 Features=0x8021bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,PGE,MMX> AMD Features=0x80000800<SYSCALL,3DNow!> real memory = 83886080 (81920K bytes) avail memory = 77217792 (75408K bytes) Preloaded elf kernel "kernel" at 0xc03d8000. md0: Malloc disk npx0: <math processor> on motherboard npx0: INT 16 interface pcib0: <Host to PCI bridge> on motherboard pci0: <PCI bus> on pcib0 isab0: <VIA 82C586 PCI-ISA bridge> at device 7.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <VIA 82C586 ATA33 controller> port 0xd000-0xd00f at device 7.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 adw0: <AdvanSys 3550 Ultra SCSI Adapter> port 0xd800-0xd83f mem 0xe6002000-0xe60020ff irq 11 at device 8.0 on pci0 adw0: SCSI ID 7, High & Low SE Term Enabled, Queue Depth 253 pci0: <Matrox MGA 1024SG/1064SG/1164SG graphics accelerator> at 9.0 irq 12 rl0: <RealTek 8139 10/100BaseTX> port 0xdc00-0xdcff mem 0xe6000000-0xe60000ff irq 12 at device 10.0 on pci0 rl0: Ethernet address: 00:50:ba:d3:90:39 miibus0: <MII bus> on rl0 rlphy0: <RealTek internal media interface> on miibus0 rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto adv0: <AdvanSys ASC3030/50 SCSI controller> port 0xe000-0xe0ff mem 0xe6001000-0xe60010ff irq 12 at device 11.0 on pci0 adv0: AdvanSys Ultra SCSI Host Adapter, SCSI ID 7, queue depth 16 adv0: driver is using old-style compatability shims pcib1: <Host to PCI bridge> on motherboard pci1: <PCI bus> on pcib1 fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 fdc0: FIFO enabled, 8 bytes threshold fd0: <1440-KB 3.5" drive> on fdc0 drive 0 atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0 atkbd0: <AT Keyboard> irq 1 on atkbdc0 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 sc0: <System console> on isa0 sc0: VGA <16 virtual consoles, flags=0x0> sio0 at port 0x3f8-0x3ff irq 4 on isa0 sio0: type 16550A sio1 at port 0x2f8-0x2ff irq 3 on isa0 sio1: type 16550A sio2 at port 0x3e8-0x3ef irq 9 on isa0 sio2: type 16550A sio3 at port 0x2e8-0x2ef irq 10 flags 0x10 on isa0 sio3: type 16550A, console ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode ppbus0: IEEE1284 device found /NIBBLE/ECP Probing for PnP devices on ppbus0: ppbus0: <HEWLETT-PACKARD DESKJET 670C> MLC,PCL,PML ppi0: <Parallel I/O> on ppbus0 lpt0: <Printer> on ppbus0 lpt0: Interrupt-driven port plip0: <PLIP network interface> on ppbus0 isa_compat: didn't get irq for lnc unknown0: <AUX0> on isa0 pcm0: <OPTi931> at port 0x534-0x537,0x380-0x38b,0x220-0x22f,0xe0c-0xe0f irq 5 drq 0,1 on isa0 AD_WAIT_INIT FAILED 1002 0xff unknown1: <Game Port> at port 0x200 on isa0 unknown: <MPU401> can't assign resources acd0: CDROM <CD-ROM DRIVE/F5A> at ata0-master using PIO4 Waiting 15 seconds for SCSI devices to settle pass4 at adv0 bus 0 target 4 lun 0 pass4: < Scanner 300A4 4.11> Fixed Scanner SCSI-2 device pass4: 3.300MB/s transfers ... Doing initial network setup: hostname. lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384 inet 127.0.0.1 netmask 0xff000000 rl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 inet 192.168.0.1 netmask 0xffffff00 broadcast 192.168.0.255 ether 00:50:ba:d3:90:39 media: autoselect (none) status: active supported media: autoselect 100baseTX <full-duplex> 100baseTX 10baseT/UTP <full-duplex> 10baseT/UTP 100baseTX <hw-loopback> Starting ppp: IP packet filtering initialized, divert disabled, rule-based forwarding disabled, default to deny, logging disabled Kernel firewall module loaded. Flushed all rules. 00100 allow ip from any to any via lo0 00200 deny ip from any to 127.0.0.0/8 65000 allow ip from any to any Firewall rules loaded, starting divert daemons:. Additional routing options: IP gateway=YES TCP keepalive=YES. routing daemons:. Mounting NFS file systems. additional daemons: syslogd. checking for core dump...savecore: /dev/rda0s1a: Device busy Feb 27 23:40:48 raven savecore: /dev/rda0s1a: Device busy Doing additional network setup: named ntpdate portmap. Starting final network daemons: mountd nfsd rpc.statd. setting ELF ldconfig path: /usr/lib /usr/lib/compat /usr/X11R6/lib /usr/local/lib setting a.out ldconfig path: /usr/lib/aout /usr/lib/compat/aout /usr/X11R6/lib/aout starting standard daemons: inetd cron printer sendmail. Recovering vi editor sessions Initial rc.i386 initialization: ibcs2 linux. rc.i386 configuring syscons: blank_time moused. Local package initialization: Modula-3 linprocfs sshdFeb 27 23:41:26 raven /kernel: /dev/vmmon: Module vmmon: registered with major=200 minor=0 tag=$Name: build-364 $ Feb 27 23:41:26 raven /kernel: /dev/vmmon: Module vmmon: initialized VMware. Additional TCP options:. Sun Feb 27 23:41:27 PST 2000 Z11 FreeBSD/i386 (raven.beattie-home.net) (ttyd3) login: kernel: type 12 trap, code=0 Stopped at adw_intr+0x131: pushl 0x5c(%esi) db> trace adw_intr(c08b6900,0,10,10,10) at adw_intr+0x131 Xresume11() at Xresume11+0x2b --- interrupt, eip = 0xc02ae6de, esp = 0xc0315a74, ebp = 0 --- default_halt() at default_halt+0x2 db> panic panic: from debugger Debugger("panic") Stopped at adw_intr+0x131: pushl 0x5c(%esi) db> panic panic: from debugger Uptime: 8h27m52s Fatal trap 12: page fault while in kernel mode fault virtual address = 0x30 fault code = supervisor read, page not present instruction pointer = 0x8:0xc09d22b2 stack pointer = 0x10:0xc03157dc frame pointer = 0x10:0xc03157e4 code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = Idle interrupt mask = cam kernel: type 12 trap, code=0 Stopped at adw_intr+0x131: pushl 0x5c(%esi) db> call boot(0) syncing disks... 117 117 117 117 117 117 117 117 117 117 117 117 117 117 117 117 117 117 117 117 giving up on 107 buffers Uptime: 8h28m34s Fatal trap 12: page fault while in kernel mode fault virtual address = 0x30 fault code = supervisor read, page not present instruction pointer = 0x8:0xc09d22b2 stack pointer = 0x10:0xc0315790 frame pointer = 0x10:0xc0315798 code segment = base 0x0, limit 0xfffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = Idle interrupt mask = cam kernel: type 12 trap, code=0 Stopped at adw_intr+0x131: pushl 0x5c(%esi) db> call cpu_reset() Brian Beattie | The only problem with beattie@aracnet.com | winning the rat race ... www.aracnet.com/~beattie | in the end you're still a rat To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.LNX.4.21.0002280835360.3617-100000>