Date: Fri, 25 May 2001 22:21:39 -0400 (EDT) From: David David <ddavid_3@yahoo.com> To: questions@freebsd.org Cc: Joey Garcia <bear@buug.homeip.net> Subject: Re: utah-glx port and Rage LT Pro anyone? Message-ID: <20010526022139.59903.qmail@web11304.mail.yahoo.com>
next in thread | raw e-mail | index | archive | help
This is what i have that's working on a Rage 3D Pro Card: glx.conf: ( /usr/X11R6/etc ) ( did some snipping for shortness) # /etc/X11/glx.conf # # $Id: glx.conf.in,v 1.17 2000/08/08 22:59:39 ehliar Exp $ # hw_boxes = 1 # # Tells the driver to draw various status information in the upper left corner # See glx/docs/debug.txt for more information. (Defaults to 0) hw_logfile = /var/log/glx.log # # Location of driver logfile # If not set log goes to Xserver's stdout hw_loglevel = >1 # # 0 => log only error messages. # 1 or not set => error + standard debugging messages # >1 => more messages # >=10 lots of messages inside each frame debug = 1 # # Enables GLX log. See docs/debug.txt for more infrmation. mach64_dma = 4 <-- start with 3 and see how it works, then try 4, i believe 4 is used for AGP2x? mach64_agptextures = 1 mach64_agpsize = 32 these settings you will find reading through the doc's in $PORTSDIR/work/utah-glx/docs, lots of info there. I would suggest skipping the ~textures and ~size above until you have things working ok. # # Valid values: 0 - 4 # mach64_drawtest = 0 # # If set the driver will do some initial rendering tests upon startup. # Useful to see if the driver is being loaded correctly. Also, in your XF86Config you need to add a module section as such: FontPath "/usr/X11R6/lib/X11/fonts/100dpi" FontPath "/usr/X11R6/lib/X11/fonts/75dpi" EndSection #Section "Module" # Load "glx.so" #EndSection Section "ServerFlags" EndSection un-comment when you want to use of coarse, also in the Card device section you require: Section "Device" Identifier "Primary Card" VendorName "Unknown" BoardName "ATI Mach64 3D Rage Pro" VideoRam 8192 # For GLX use #Option "no_font_cache" #Option "no_pixmap_cache" and once again un-comment for use of GLX. Utah-glx requires Mesa-3.2.1, which is not in the ports anymore, so you will need to download MesaDemos-3.2.1.tar.bz2, MesaLib-3.2.1.tar.bz2 to compile UTAH-GLX. Hope this helps... David PS: to check out the demo's go into the work/Mesa-3.2.1/demos type "make" for each .c file , there's also an xdemos dir with some demo's. _______________________________________________________ Do You Yahoo!? Get your free @yahoo.ca address at http://mail.yahoo.ca To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010526022139.59903.qmail>