Date: Tue, 5 Dec 2000 12:52:50 GMT From: postmaster@freebie.demon.nl To: gallatin@freebsd.org Cc: freebsd-alpha@freebsd.org Subject: Test results for Lynx/-current Message-ID: <E143HaU-0005Qj-00@post.mail.nl.demon.net>
next in thread | raw e-mail | index | archive | help
[-- Attachment #1 --]
Hi Drew,
Attached the boot messages for Lynx based on your test kernel you put
up for ftp yesterday.
HTH,
Wilko
[-- Attachment #2 --]
Script started on Tue Dec 5 11:54:29 2000
bash-2.04# tip a
P00>>>sho mem
Module Size Base Addr Intlv Mode Intlv Unit Status
------ ----- --------- ---------- ---------- ------
0 128MB 00000000 1-Way 0 Passed
Total Bad Pages 0
P00>>>sho conf
Digital Equipment Corporation
AlphaServer 2100A 4/200
SRM Console V5.3-10 VMS PALcode V5.56-7, OSF PALcode V1.45-12
Component Status Module ID
CPU 0 P B2020-AA DECchip (tm) 21064-3
Memory 0 P B2021-CA 128 MB
I/O B2222-AA
dva0.0.0.1000.0 RX26/RX23
Slot Option Hose 0, Bus 0, PCI
2 Intel 82375 Bridge to Bus 1, EISA
3 DECchip 21050-AA Bridge to Bus 2, PCI
7 DECchip 21040-AA ewa0.0.0.7.0 00-00-F8-23-16-31
9 QLogic ISP1020 pkb0.7.0.9.0 SCSI Bus ID 7
Slot Option Hose 0, Bus 1, EISA
1 Compaq Qvision
3 Mylex DAC960 dra.0.0.1003.0
dra0.0.0.1003.0 5 Member RAID 5
Slot Option Hose 0, Bus 2, PCI
1 NCR 53C810 pka0.7.0.2001.0 SCSI Bus ID 7
dka600.6.0.2001.0 RRD43
6 Mylex DAC960 drb.0.0.2006.0
drb0.0.0.2006.0 2 Member RAID 1
drb1.0.0.2006.0 2 Member RAID 1
drb2.0.0.2006.0 2 Member RAID 1
P00>>>sho dev
dka600.6.0.2001.0 DKA600 RRD43 1084
dra0.0.0.1003.0 DRA0 5 Member RAID 5
drb0.0.0.2006.0 DRB0 2 Member RAID 1
drb1.0.0.2006.0 DRB1 2 Member RAID 1
drb2.0.0.2006.0 DRB2 2 Member RAID 1
dva0.0.0.1000.0 DVA0 RX26/RX23
ewa0.0.0.7.0 EWA0 00-00-F8-23-16-31
pka0.7.0.2001.0 PKA0 SCSI Bus ID 7
pkb0.7.0.9.0 PKB0 SCSI Bus ID 7 5.57
P00>>>
P00>>>boot dva0
Halt Button is IN, BOOT NOT POSSIBLE
P00>>>boot dva0
(boot dva0.0.0.1000.0 -flags 0,0)
block 0 of dva0.0.0.1000.0 is a valid boot block
reading 15 blocks from dva0.0.0.1000.0
bootstrap code read in
base = 200000, image_start = 0, image_bytes = 1e00
initializing HWRPB at 2000
initializing page table at 7ff0000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/Loading /boot/loader
-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-Console: SRM firmware console
VMS PAL rev: 0x4000700010538
OSF PAL rev: 0x4000c0002012d
Switch to OSF PAL code succeeded.
FreeBSD/alpha SRM disk boot, Revision 1.1
(rootk@quynh.nuxi.com, Mon Nov 27 05:39:53 GMT 2000)
Memory: 131072 k
|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|//kernel data=0x294a30+0x2b320 -\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\syms=[0x8+0x37ef0|/-\|/-\|/-\|/+0x8+0x2934f-\|/-\|/-\|]
Please insert MFS root floppy and press enter:
/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [/kernel] in 9 seconds... Booting [/kernel] in 8 seconds... Booting [/kernel] in 7 seconds... Booting [/kernel] in 6 seconds... Booting [/kernel] in 5 seconds... Booting [/kernel] in 4 seconds... Booting [/kernel] in 3 seconds... Booting [/kernel] in 2 seconds... Booting [/kernel] in 1 second... Booting [/kernel]...
-\|/-\Entering kernel at 0xfffffc0000327f20...
Unrecognized boot flag '0'.
Unrecognized boot flag ','.
Unrecognized boot flag '0'.
Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #14: Sun Dec 3 23:02:29 EST 2000
gallatin@thunder.cs.duke.edu:/.amd_mnt/muffin/export/ari_scratch2/gallatin/current/sys/compile/SABLE
DEC AlphaServer 2100A
AlphaServer 2100A 4/200, 190MHz
8192 byte page size, 1 processor.
CPU: EV4 (21064) major=2 minor=1
OSF PAL rev: 0x4000c0002012d
real memory = 132046848 (128952K bytes)
avail memory = 120643584 (117816K bytes)
Preloaded elf kernel "kernel" at 0xfffffc00008f4000.
Preloaded mfs_root "/mfsroot" at 0xfffffc00008f40c0.
md0: Preloaded image </mfsroot> 2949120 bytes at 0xfffffc0000620fa0
md1: Malloc disk
t20: using interrupt type 1 on pci bus 0
t20: <T2 Core Logic chipset>
pci0: <PCI bus> on pcib0
isab0: <Intel 82375EB PCI-EISA bridge> at device 2.0 on pci0
isa0: <ISA bus> on isab0
pcib1: <DEC 21050 PCI-PCI bridge> at device 3.0 on pci0
pci1: <PCI bus> on pcib1
sym0: <810a> port 0x5000-0x50ff mem 0x81004000-0x810040ff irq 28 at device 1.0 on pci1
sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
sym0: interrupting at T2 irq 28 (stdio irq 28)
pci1: <unknown card> (vendor=0x1069, dev=0x0001) at 6.0 irq 48
de0: <Digital 21040 Ethernet> port 0x10100-0x1017f mem 0x81111000-0x8111107f irq 36 at device 7.0 on pci0
de0: interrupting at T2 irq 36 (stdio irq 36)
de0: DEC 21040 [10Mb/s] pass 2.4
de0: address 00:00:f8:23:16:31
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: interrupting at T2 irq 6 (stdio irq 7)
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
atkbd0: interrupting at T2 irq 1 (stdio irq 6)
psm: keyboard controller failed.
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x0>
mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A, console
sio0: interrupting at T2 irq 4 (stdio irq 15)
sio1: reserved for low-level i/o
ppc0: <Parallel port> at port 0x3bc-0x3bf irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
plip0: cannot reserve interrupt, failed.
ppi0: <Parallel I/O> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Polled port
ppc0: interrupting at T2 irq 7 (stdio irq 9)
Timecounter "i8254" frequency 1193182 Hz
Timecounter "alpha" frequency 190008207 Hz
de0: autosense failed: cable problem?
halted CPU 0
halt code = 1
operator initiated halt
PC = fffffc00005015f8
P00>>> ~
[EOT]
bash-2.04#
bash-2.04# exit
Script done on Tue Dec 5 12:21:38 2000
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?E143HaU-0005Qj-00>