Date: Mon, 18 Aug 2003 08:45:40 -0400 From: Bill Moran <wmoran@potentialtech.com> To: Andre Guibert de Bruet <andy@siliconlandmark.com> Cc: freebsd-current@freebsd.org Subject: Re: Slow Boot Message-ID: <3F40CA74.6060805@potentialtech.com> In-Reply-To: <20030817223400.O320@alpha.siliconlandmark.com> References: <20030817102318.69e094fc.aelfgar@aelfgar.com> <3F3FCFB2.3050900@potentialtech.com> <20030817223400.O320@alpha.siliconlandmark.com>
next in thread | previous in thread | raw e-mail | index | archive | help
Andre Guibert de Bruet wrote:
> What does pciconf -vl show on the affected machine(s)?
chip0@pci0:0:0: class=0x060000 card=0x00000000 chip=0x12378086 rev=0x02 hdr=0x00
vendor = 'Intel Corporation'
device = '82440/1FX 440FX (Natoma) System Controller'
class = bridge
subclass = HOST-PCI
isab0@pci0:1:0: class=0x060100 card=0x00000000 chip=0x70008086 rev=0x01 hdr=0x00
vendor = 'Intel Corporation'
device = '82371SB PIIX3 PCI-to-ISA Bridge (Triton II)'
class = bridge
subclass = PCI-ISA
atapci0@pci0:1:1: class=0x010180 card=0x00000000 chip=0x70108086 rev=0x00 hdr=0x00
vendor = 'Intel Corporation'
device = '82371SB PIIX3 IDE Interface (Triton II)'
class = mass storage
subclass = ATA
none0@pci0:1:2: class=0x0c0300 card=0x00000000 chip=0x70208086 rev=0x01 hdr=0x00
vendor = 'Intel Corporation'
device = '82371SB PIIX3 USB Host Controller (Triton II)'
class = serial bus
subclass = USB
xl0@pci0:10:0: class=0x020000 card=0x100010b7 chip=0x920010b7 rev=0x74 hdr=0x00
vendor = '3COM Corp, Networking Division'
device = '3C905C-TX Fast EtherLink for PC Management NIC'
class = network
subclass = ethernet
rl0@pci0:11:0: class=0x020000 card=0x813910ec chip=0x813910ec rev=0x10 hdr=0x00
vendor = 'Realtek Semiconductor'
device = 'RT8139 (A/B/C/8130) Fast Ethernet Adapter'
class = network
subclass = ethernet
none1@pci0:12:0: class=0x030000 card=0x47501002 chip=0x47501002 rev=0x5c hdr=0x00
vendor = 'ATI Technologies'
device = 'Rage 3D Pro PCI Graphics Accelerator'
class = display
subclass = VGA
e fu
>>Andre Guibert de Bruet | Enterprise Software Consultant >
>>Silicon Landmark, LLC. | http://siliconlandmark.com/ >
>
>
> On Sun, 17 Aug 2003, Bill Moran wrote:
>
>
>>Mike Atamas wrote:
>>
>>>When my system boots it seems to stall when it gets here:
>>>
>>>xa807,0xa400-0xa403,0xa000-0xa007 mem 0xe1000000-0xe10001ff irq 11 at device 11.
>>>0 on pci1
>>>ata2: at 0xe1000000 on atapci0
>>>ata3: at 0xe1000000 on atapci0
>>>
>>>It stalls for about 20-30 seconds and then continues booting. I can not figure out
>>>what the problem is or how to solve it. Has anyone had similar issues.
>>
>>I've seen this on various hardware. I actually have a 200mhz machine sitting here
>>that has always done this. I've never seen it cause any problems, and I've never
>>had any suggestions on how to stop it either.
>>
>>My best guess is that the chipset responds slowly to probes, thus it takes a while
>>to get the list of devices from it. However, I've never looked into it any more
>>than that.
>
>
>
--
Bill Moran
Potential Technologies
http://www.potentialtech.com
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3F40CA74.6060805>