Date: Thu, 05 Apr 2012 13:07:55 +0800 From: David Xu <listlog2011@gmail.com> To: freebsd-hackers@freebsd.org Subject: Re: Startvation of realtime piority threads Message-ID: <4F7D28AB.605@gmail.com> In-Reply-To: <20120405035645.GO2358@deviant.kiev.zoral.com.ua> References: <1333590846.58474.YahooMailClassic@web180011.mail.gq1.yahoo.com> <20120405035645.GO2358@deviant.kiev.zoral.com.ua>
next in thread | previous in thread | raw e-mail | index | archive | help
On 2012/4/5 11:56, Konstantin Belousov wrote: > On Wed, Apr 04, 2012 at 06:54:06PM -0700, Sushanth Rai wrote: >> I have a multithreaded user space program that basically runs at realtime priority. Synchronization between threads are done using spinlock. When running this program on a SMP system under heavy memory pressure I see that thread holding the spinlock is starved out of cpu. The cpus are effectively consumed by other threads that are spinning for lock to become available. >> >> After instrumenting the kernel a little bit what I found was that under memory pressure, when the user thread holding the spinlock traps into the kernel due to page fault, that thread sleeps until the free pages are available. The thread sleeps PUSER priority (within vm_waitpfault()). When it is ready to run, it is queued at PUSER priority even thought it's base priority is realtime. The other siblings threads that are spinning at realtime priority to acquire the spinlock starves the owner of spinlock. >> >> I was wondering if the sleep in vm_waitpfault() should be a MAX(td_user_pri, PUSER) instead of just PUSER. I'm running on 7.2 and it looks like this logic is the same in the trunk. > It just so happen that your program stumbles upon a single sleep point in > the kernel. If for whatever reason the thread in kernel is put off CPU > due to failure to acquire any resource without priority propagation, > you would get the same effect. Only blockable primitives do priority > propagation, that are mutexes and rwlocks, AFAIR. In other words, any > sx/lockmgr/sleep points are vulnerable to the same issue. This is why I suggested that POSIX realtime priority should not be boosted, it should be only higher than PRI_MIN_TIMESHARE but lower than any priority all msleep() callers provided. The problem is userland realtime thread 's busy looping code can cause starvation a thread in kernel which holding a critical resource. In kernel we can avoid to write dead-loop code, but userland code is not trustable. If you search "Realtime thread priorities" in 2010-december within @arch list. you may find the argument. > Speaking of exactly your problem, did you considered wiring the memory > of your realtime process ? This is a common practice, used e.g. by ntpd.
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?4F7D28AB.605>