Date: Sat, 11 Sep 2004 16:28:25 +0200 From: Marc "UBM" Bocklet <ubm@u-boot-man.de> To: current@freebsd.org Subject: two LORs with acx driver and 6-current Message-ID: <20040911162825.418068e7.ubm@u-boot-man.de>
index | next in thread | raw e-mail
[-- Attachment #1 --] Hiho! :-) I played around a bit with the acx driver from wlan.kewl.org and encountered the following two LORs in the process. This time I was intelligent enough to consult the LOR page first, but I did not find them listed there. What I did: configure acx0 for hostap mode enable bridging between acx0 and rl0 connect to the acx0 access point via another wlan card. More info: running with debug.mpsafenet=1 FreeBSD ubm.marines 6.0-CURRENT FreeBSD 6.0-CURRENT #4: Wed Aug 25 20:33:53 CEST 2004 root@ubm.marines:/usr/obj/usr/src/sys/SHEEP i386 dmesg is attached. Teh LORs: http://www.u-boot-man.de/~mbocklet/lors.txt Hope this helps. :-) Bye Marc -- "And what rough beast, its hour come round at last, Slouches towards Bethlehem to be born?" W.B. Yeats, The Second Coming [-- Attachment #2 --] Copyright (c) 1992-2004 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 6.0-CURRENT #4: Wed Aug 25 20:33:53 CEST 2004 root@ubm.marines:/usr/obj/usr/src/sys/SHEEP WARNING: WITNESS option enabled, expect reduced performance. Timecounter "i8254" frequency 1193182 Hz quality 0 CPU: Intel(R) Pentium(R) 4 CPU 2.40GHz (2393.94-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0xf24 Stepping = 4 Features=0x3febfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM> real memory = 536805376 (511 MB) avail memory = 515620864 (491 MB) ACPI APIC Table: <IntelR AWRDACPI> Pentium 4 TCC support enabled, 8 steps from 100% to 13%, current performance 50% ioapic0 <Version 2.0> irqs 0-23 on motherboard npx0: [FAST] npx0: <math processor> on motherboard npx0: INT 16 interface acpi0: <IntelR AWRDACPI> on motherboard acpi0: Power Button (fixed) Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000 acpi_timer0: <24-bit timer at 3.579545MHz> port 0x408-0x40b on acpi0 cpu0: <ACPI CPU> on acpi0 acpi_tz0: <Thermal Zone> on acpi0 acpi_button0: <Power Button> on acpi0 pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0 pci0: <ACPI PCI bus> on pcib0 agp0: <Intel 82850 host to AGP bridge> mem 0xe0000000-0xe3ffffff at device 0.0 on pci0 pcib1: <PCI-PCI bridge> at device 1.0 on pci0 pci1: <PCI bus> on pcib1 pci1: <display, VGA> at device 0.0 (no driver attached) pci1: <display> at device 0.1 (no driver attached) uhci0: <Intel 82801DB (ICH4) USB controller USB-A> port 0xd800-0xd81f irq 16 at device 29.0 on pci0 uhci0: [GIANT-LOCKED] usb0: <Intel 82801DB (ICH4) USB controller USB-A> on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered uhci1: <Intel 82801DB (ICH4) USB controller USB-B> port 0xd000-0xd01f irq 19 at device 29.1 on pci0 uhci1: [GIANT-LOCKED] usb1: <Intel 82801DB (ICH4) USB controller USB-B> on uhci1 usb1: USB revision 1.0 uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub1: 2 ports with 2 removable, self powered uhci2: <Intel 82801DB (ICH4) USB controller USB-C> port 0xd400-0xd41f irq 18 at device 29.2 on pci0 uhci2: [GIANT-LOCKED] usb2: <Intel 82801DB (ICH4) USB controller USB-C> on uhci2 usb2: USB revision 1.0 uhub2: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub2: 2 ports with 2 removable, self powered ehci0: <EHCI (generic) USB 2.0 controller> mem 0xe4200000-0xe42003ff irq 23 at device 29.7 on pci0 ehci0: [GIANT-LOCKED] ehci_pci_attach: companion usb0 ehci_pci_attach: companion usb1 ehci_pci_attach: companion usb2 usb3: EHCI version 1.0 usb3: companion controllers, 2 ports each: usb0 usb1 usb2 usb3: <EHCI (generic) USB 2.0 controller> on ehci0 usb3: USB revision 2.0 uhub3: Intel EHCI root hub, class 9/0, rev 2.00/1.00, addr 1 uhub3: 6 ports with 6 removable, self powered pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0 pci2: <ACPI PCI bus> on pcib2 atapci0: <HighPoint HPT372 UDMA133 controller> port 0xb000-0xb0ff,0xac00-0xac03,0xa800-0xa807,0xa400-0xa403,0xa000-0xa007 irq 23 at device 0.0 on pci2 ata2: channel #0 on atapci0 ata3: channel #1 on atapci0 rl0: <RealTek 8139 10/100BaseTX> port 0xb400-0xb4ff mem 0xe4134000-0xe41340ff irq 18 at device 1.0 on pci2 miibus0: <MII bus> on rl0 rlphy0: <RealTek internal media interface> on miibus0 rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto rl0: Ethernet address: 00:04:61:42:d8:ba fwohci0: <Texas Instruments TSB43AB22/A> mem 0xe4130000-0xe4133fff,0xe4136000-0xe41367ff irq 20 at device 3.0 on pci2 fwohci0: OHCI version 1.10 (ROM=0) fwohci0: No. of Isochronous channels is 4. fwohci0: EUI64 00:04:61:00:00:00:66:62 fwohci0: Phy 1394a available S400, 2 ports. fwohci0: Link S400, max_rec 2048 bytes. firewire0: <IEEE1394(FireWire) bus> on fwohci0 fwe0: <Ethernet over FireWire> on firewire0 if_fwe0: Fake Ethernet address: 02:04:61:00:66:62 fwe0: Ethernet address: 02:04:61:00:66:62 fwe0: if_start running deferred for Giant sbp0: <SBP-2/SCSI over FireWire> on firewire0 fwohci0: Initiate bus reset fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me) firewire0: bus manager 0 (me) acx0: <Texas Instruments (TI) 802.11b+ 22Mbps Wireless Adapter> port 0xb800-0xb81f mem 0xe4120000-0xe412ffff,0xe4135000-0xe4135fff irq 20 at device 6.0 on pci2 acx0: Ethernet address: 00:03:2f:09:ad:91 acx0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps acx0: 802.11 address: 00:03:2f:09:ad:91 acx0: Eeprom Rev 4 Domain ETSI Europe (1-13), Firmware Rev 1.9.8.b acx0: Radio Type 0x11, Antenna 0x00, CCA Mode 0x0d, ED Threshold 0x70 acx0: (c) http://wlan.kewl.org/ 2003-2004 pci2: <multimedia, audio> at device 7.0 (no driver attached) isab0: <PCI-ISA bridge> at device 31.0 on pci0 isa0: <ISA bus> on isab0 atapci1: <Intel ICH4 UDMA100 controller> port 0xf000-0xf00f,0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 at device 31.1 on pci0 ata0: channel #0 on atapci1 ata1: channel #1 on atapci1 ichsmb0: <Intel 82801DC (ICH4) SMBus controller> port 0x500-0x51f irq 17 at device 31.3 on pci0 ichsmb0: [GIANT-LOCKED] smbus0: <System Management Bus> on ichsmb0 fdc0: <floppy drive controller> port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0 fdc0: ic_type 90 part_id 80 sio0 port 0x3f8-0x3ff irq 4 on acpi0 sio0: type 16550A sio1 port 0x2f8-0x2ff irq 3 on acpi0 sio1: type 16550A ppc0 port 0x778-0x77b,0x378-0x37f irq 7 drq 3 on acpi0 ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode ppc0: FIFO with 16/16/9 bytes threshold ppbus0: <Parallel port bus> on ppc0 plip0: <PLIP network interface> on ppbus0 lpt0: <Printer> on ppbus0 lpt0: Interrupt-driven port ppi0: <Parallel I/O> on ppbus0 atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0 atkbd0: <AT Keyboard> irq 1 on atkbdc0 kbd0 at atkbd0 atkbd0: [GIANT-LOCKED] psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: [GIANT-LOCKED] psm0: model MouseMan+, device ID 0 orm0: <ISA Option ROM> at iomem 0xc0000-0xccfff on isa0 pmtimer0 on isa0 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 Timecounter "TSC" frequency 2393936196 Hz quality 800 Timecounters tick every 10.000 msec ATAPI_RESET time = 18420us ATAPI_RESET time = 30us acd0: CDRW <_NEC DVD+RW ND-1100A/1.A3> at ata0-master UDMA33 acd1: CDRW <LITE-ON LTR-12101B/LS3G> at ata0-slave PIO4 ATAPI_RESET time = 10us ad2: 38166MB <ST340015A/3.01> [77545/16/63] at ata1-master UDMA100 acd2: DVDROM <TOSHIBA DVD-ROM SD-M1712/J004> at ata1-slave UDMA33 ad4: 76319MB <ST380020A/3.39> [155061/16/63] at ata2-master UDMA100 ad6: 78167MB <Maxtor 4R080L0/RAMB1TU0> [158816/16/63] at ata3-master UDMA133 ad7: 58627MB <Maxtor 4D060H3/DAH017K0> [119117/16/63] at ata3-slave UDMA100 Mounting root from ufs:/dev/ad2s4ahelp
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20040911162825.418068e7.ubm>