Date: Fri, 16 May 2003 12:14:25 +0200 From: Ruben van Staveren <ruben@verweg.com> To: Eric Anholt <eta@lclark.edu> Cc: freebsd-stable@freebsd.org Subject: Re: Problem with Matrox G450 and XFree86 4.3.0 on 4.8-STABLE Message-ID: <20030516101425.GA40726@erg.verweg.com> In-Reply-To: <1052946539.661.5.camel@leguin> References: <01b501c3155d$c0397a40$4508a8c0@Beastie> <200305110858.58951.freebsd.nospam@mekanix.dk> <20030514110427.GA15219@erg.verweg.com> <1052946539.661.5.camel@leguin>
next in thread | previous in thread | raw e-mail | index | archive | help
On Wed, May 14, 2003 at 02:09:00PM -0700, Eric Anholt wrote: > > > > Shortly after the upgrade to 4.3.0 (the initial submit to the ports showed no > > problems at that time) my MGA-450 wouldn't do full screen video anymore using > > the xv extension, and using mplayer -vo sdl -vm -fs -zoom would change to a > > video mode (-vm yes) that rendered the X server unusable: high load and no > > signal to the monitor. > > Was it by chance on any mode switch (ctrl-atl-plus/minus), and is it It happens with modes lower than 320x240 which is already a bit gibberisch when using gvid to change resolutions it first used only the resolutions I had defined in the 'Section "Screen"' but now it lists every resolution it can think off. I had tried with drm and dri off, and even with a plain vanilla XF86Config. When investigating things I also discovered drm wasn't working anymore either: (II) MGA(0): [drm] failure adding irq handler, there is a device already using that irq [drm] falling back to irq-free operation (==) MGA(0): Direct rendering enabled but glxinfo claims not. (config, logs and dmesg available upon request) > still around? If so, does it go away without the DRM? Can you connect > to the machine from elsewhere after it happens? Yes I can connect to it from remote, but the Xserver is using up all CPU making killing it a bit hard sometimes. Regards, Ruben
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20030516101425.GA40726>