Date: Thu, 9 Nov 95 11:10:06 +0300 From: "Alecander P. Kovtushenko" <sasha@hobbit.msk.su> To: questions@freebsd.org Subject: Help ! Message-ID: <AAUTRemKK3@hobbit.msk.su>
next in thread | raw e-mail | index | archive | help
Help !!
I have troubles in PC hardware compatibility with BSD 2.0.
I have: mainboard OPTI 486 VL-BUS
intel 486 DX2/50
8 mbyte RAM
325 mbyte IDE disk + 230 mbyte IDE disk.
recognized as mcd0 Panasonic CD drive.
CMOS and chipset setup are
are been configurated "power-on defaults".
Installing FreeBSD fails (is unstable)
after boot from hard disk.
Partisions of the wd0 are
a 52 /
b 30 swap
c
d
e 20 /var
f 3 /msdos
g 168 /usr
h 52 /usr/X11R6
Command available after boot from hard disk in /stand
(ex.: ls, cp, mv, mkdir, ... ) work well.
Installing from DOS partishion (wd1e)
works for small parts (manpages, games, etc.),
but for bigger one (bindist, sourcedist) fails.
The message is
fail reading 0x0 page from kernel.
Installing from mcd0 usually
fail with the same diagnostic
even for small parts.
What should I try to do?
Alexander Kovtushenko
e-mail: sasha@hobbit.msk.su
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?AAUTRemKK3>