Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 5 Dec 2003 12:28:01 -0800 (PST)
From:      Dan Strick <strick@covad.net>
To:        freebsd-hardware@FreeBSD.ORG
Cc:        dan@mist.nodomain
Subject:   Re: Incorrect identification of ultra dma ATA cables
Message-ID:  <200312052028.hB5KS1WN001285@mist.nodomain>

next in thread | raw e-mail | index | archive | help
Dan Strick wrote:
>
> I tried three different 80 conductor UDMA cables.  I examined them
> carefully.  I even checked for correct wiring of the PDIAG/CBLID
> signal lines with an ohmmeter.

Then Bohdan Tashchuk wrote:
> 
> I've got one simple idea for you to try. You probably did this already
> but you don't say so explicitly.
> 
> The 80 conductor cables are color coded. Blue connector goes to the
> motherboard, black connector to the master drive, grey connector to the
> slave drive.
> 
> Did you plug the cable in the right way?

Then Ion-Mihai Tetcu wrote:
> 
> Well, I'm just sitting here and waching a few 80 conductor cables and
> they are:
> black - black - black x 3
> black - grey - black x 5
> blue - grey - black x 1
> red - grey - black x 1
> 
> And the nice thing is that all are from Gigabyte motherboards boxes.
>>>

Yes, I plugged the cables in the right way.  The motherboard end, which
is supposed to use a blue socket connector, is the end that is not
connected to the PDIAG/CBLID signal line.

My Gigabyte motheboard did come with some astonishingly gaudy UDMA
cables.  Two were bright yellow with green (instead of blue) host
end connectors and a bright red stripe along the conductor#1 edge
of the cable.  One grey cable had a red (instead of blue) connector.
As near as I can tell, the electrons still drift along at pretty
much the same old speed regardless of the color.

Dan Strick
strick@covad.net



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200312052028.hB5KS1WN001285>