Date: Tue, 21 Oct 1997 09:33:03 -0700 (PDT) From: Doug White <dwhite@gdi.uoregon.edu> To: Gang-Ryung Uh <uh@NU.cs.fsu.edu> Cc: questions@FreeBSD.ORG Subject: Re: 3C589D PCMCIA card configuration Message-ID: <Pine.BSF.3.96.971021093032.1984D-100000@gdi.uoregon.edu> In-Reply-To: <199710211500.LAA29317@upsilon.cs.fsu.edu>
next in thread | previous in thread | raw e-mail | index | archive | help
On Tue, 21 Oct 1997, Gang-Ryung Uh wrote: > I am running 2.2.2 with PAO package on NEC versa laptop > I would like to configure 3C589D PCMCIA card for the laptop. > > I looked at the config file and check IO address and interrupt > queue seems correct. > > During the boot time: > > ------ > ep0 not found at 0x300 <---- ??? that's correct. > PC-Card VLSI 82C146 (5 mem & 2 I/O windows) > pcic: controller irq 3 > Card inserted, slot 0 > Slot 0, unfielded interrupt (0) > ep0: utp/bnc[*UTP*] address 00:60:97:8d:d0:45 This is good. > After the boot, I typed "ifconfig -a" > ep0: flags=8802<BROADCAST,SIMPLEX,MULTICASE> mtu 1500 > ether 00:60:..:..:..:.. > I set the "rc.conf" as follows, but ep0 is not up and running: The PCCARD system is a bit different from the standard since cards can come & go and it takes a while once the kernel finishes to pick up the card. By the time it's config'd and attached, the ifconfig lines in rc.network are long gone. The PAO system, from http://www.jp.freebsd.org/PAO/, can handle resetting the card after insertion. That, or manually re-ifconfig the card after inserting it. Doug White | University of Oregon Internet: dwhite@resnet.uoregon.edu | Residence Networking Assistant http://gladstone.uoregon.edu/~dwhite | Computer Science Major
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.3.96.971021093032.1984D-100000>