Date: Sun, 5 Jun 2011 14:29:11 -0500 From: Espartano <espartano.mail@gmail.com> To: Warner Losh <imp@bsdimp.com> Cc: freebsd-embedded@freebsd.org Subject: Re: Problem with NanoBSD And Alix Board not device boot Message-ID: <BANLkTin2negQ3f2McrKQhUKu%2Bbp%2BGcSO4A@mail.gmail.com> In-Reply-To: <E18BA1D4-C2A7-4FE7-A1A4-0C5B6FDD60DB@bsdimp.com> References: <BANLkTikZx=uxokXcpQUi2jksgdMaUp4_%2BQ@mail.gmail.com> <E18BA1D4-C2A7-4FE7-A1A4-0C5B6FDD60DB@bsdimp.com>
index | next in thread | previous in thread | raw e-mail
On Sun, Jun 5, 2011 at 11:57 AM, Warner Losh <imp@bsdimp.com> wrote: > > On Jun 5, 2011, at 12:40 AM, Espartano wrote: >> NANO_BOOT0CFG="-o nopacket -s 1 -m 3" > > nopacket mode is the hardest of all modes to use. Your CF's reported geometry *MUST* be encoded properly in the nano config file. This isn't the geometry that the CF card reader reports, but what the CF card reports in true IDE mode. This will vary from card to card (even cards with exactly the same label). Unless your boot loader doesn't support packet mode properly, I'd strongly urge you to use packet mode. > Ok, I will put geometry of my CF into nanobsd config file, I hope that will fix my problem. >> When I copy the NanoBSD image builded into the CF Card I has used this command: >> >> dd if=_.disk.image of=/dev/sdc bs=64k > that was my mistake, but even using _.disk.full file I get the same error.help
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?BANLkTin2negQ3f2McrKQhUKu%2Bbp%2BGcSO4A>