Date: Sun, 3 Mar 2002 19:41:33 +0100 (CET) From: Søren Schmidt <sos@freebsd.dk> To: current@freebsd.org Subject: Request for testers of ATA RAID support Message-ID: <200203031841.g23IfXB31877@freebsd.dk>
next in thread | raw e-mail | index | archive | help
As some might have noticed I've done some significant work on the ATA RAID support (for Promise & Highpoint controllers) all thanks to Advanis which has made this possible. The code as it is now in -current allows for RAID1's (mirrors) to be properly handled when a disk dies, that means the system continues on the good disk and logs the loss of mirror to the console. The hotswap part of the ATA driver has been extended with functions to enable the bad disk to be detached with atacontrol and if it is in a removeable enclosure, it can be swapped with a new good disk even while the system is running. When the new disk is attached again with atacontrol, the ATA driver will mark it as a SPARE disk if its located where the failed disk was before. Now the really interesting part is the new rebuild command in atacontrol, that will bring the SPARE disk up to date, and when done will set the RAID to fully functional again. All the above is properly written to the config sectors on the disks, so that the BIOS will pick up any changes that happend when the ATA driver was in control. If you have Promise SuperSwap enclosures, the state of the disks will be shown by the LEDs, red for broken disk, orange for rebuilding and green for online. All this said I need testers to really give this new functionality a run for its money, so please, if you have the HW needed for this (Promise Fasttrak or a Highpoint controller with ATA disks) please give it a whirl and let me know how it works out. Thanks! -Søren To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200203031841.g23IfXB31877>