Date: Fri, 14 May 1999 10:50:27 +0200 (CEST) From: Peter Hakanson <peter@netman.se> To: freebsd-multimedia@freebsd.org Subject: Machine hangs when using h261 encoding Message-ID: <Pine.BSF.3.96.990514104645.4046G-100000@warp.hq.gbg.netman.se>
index | next in thread | raw e-mail
When trying the "mbone-tools" i discovered an
anomaly :
using vic might get the system to hang. Hard, does
not answer to ping, no reaction to any keys, mouse dead.
No logging in syslog. Just simply dies(hard). Manual
reboot needed.
It seems to be triggered by switching between video modes,
switchning into or out of h.261 (or enabling transmit when
using h261 mode).
The system is 2.2.7, i have read through the brooktree driver for
3.1 but cannot find fixes for this kind of problem.
Ethernet card is inter pro 10/100 in 10mbit speed.
Camera is Pxelview meetimg pac PAL version.
board is a TYN TITAN VX V3.0
Booting -v shows up this info
Copyright (c) 1992-1998 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 2.2.7-RELEASE #0: Tue May 11 18:12:14 CEST 1999
root@benet.gbg.netman.se:/usr/src/sys/compile/MBONE-PCM
Calibrating clock(s) ... i586 clock: 199425948 Hz, i8254 clock: 1193148 Hz
CLK_USE_I8254_CALIBRATION not specified - using default frequency
CLK_USE_I586_CALIBRATION not specified - using old calibration method
CPU: Pentium/P55C (199.43-MHz 586-class CPU)
Origin = "GenuineIntel" Id = 0x544 Stepping=4
Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory = 67108864 (65536K bytes)
Physical memory chunk(s):
0x00001000 - 0x0009efff, 647168 bytes (158 pages)
0x00251000 - 0x03ffdfff, 64671744 bytes (15789 pages)
avail memory = 63168512 (61688K bytes)
DPT: RAID Manager driver, Version 1.0.5
pcibus_setup(1): mode 1 addr port (0x0cf8) is 0x80000058
pcibus_setup(1a): mode1res=0x80000000 (0x80000000)
pcibus_check: device 0 is there (id=70308086)
Probing for devices on PCI bus 0:
configuration mode 1 allows 32 devices.
chip0 <Intel 82437VX PCI cache memory controller> rev 2 on pci0:0:0
PCI Concurrency: enabled
Cache: 256K pipelined-burst secondary; L1 enabled
DRAM: no memory hole, 66 MHz refresh
Read burst timing: x-2-2-2/x-3-3-3
Write burst timing: x-2-2-2
RAS-CAS delay: 3 clocks
chip1 <Intel 82371SB PCI-ISA bridge> rev 1 on pci0:7:0
I/O Recovery Timing: 8-bit 1 clocks, 16-bit 1 clocks
Extended BIOS: disabled
Lower BIOS: disabled
Coprocessor IRQ13: enabled
Mouse IRQ12: enabled
Interrupt Routing: A: IRQ11, B: IRQ10, C: disabled, D: IRQ9
MB0: IRQ15, MB1:
chip2 <Intel 82371SB IDE interface> rev 0 on pci0:7:1
mapreg[20] type=1 addr=0000f000 size=0010.
Primary IDE: enabled
Secondary IDE: enabled
vga0 <VGA-compatible display device> rev 1 int a irq 9 on pci0:12:0
mapreg[10] type=0 addr=e0900000 size=4000.
mapreg[14] type=0 addr=e0000000 size=800000.
fxp0 <Intel EtherExpress Pro 10/100B Ethernet> rev 2 int a irq 10 on pci0:14:0
mapreg[10] type=0 addr=e0904000 size=1000.
mapreg[14] type=1 addr=00006100 size=0020.
mapreg[18] type=0 addr=e0800000 size=100000.
reg16: virtual=0xf5690000 physical=0xe0904000 size=0x1000
fxp0: Ethernet address 00:a0:c9:42:41:d8
bpf: fxp0 attached
bktr0 <BrookTree 848> rev 18 int a irq 11 on pci0:15:0
mapreg[10] type=0 addr=e0905000 size=1000.
reg16: virtual=0xf5691000 physical=0xe0905000 size=0x1000
brooktree0: PCI bus latency is 32.
bktr0: buffer size 3555328, addr 0x3000000
bktr: GPIO is 0x00ffffff
Hauppauge WinCast/TV, Temic NTSC tuner, dbx stereo, msp3400c stereo.
pci0: uses 9461760 bytes of memory from e0000000 upto e0905fff.
pci0: uses 48 bytes of I/O space from 6100 upto f00f.
Probing for PnP devices:
Trying Read_Port at 203
Trying Read_Port at 243
CSN 1 Vendor ID: CTLfff1 [0xf1ff8c0e] Serial 0x1005a1d6
Probing for devices on the ISA bus:
sc0: the current keyboard controller command byte 0047
kbdio: DIAGNOSE status:0055
kbdio: TEST_KBD_PORT status:0000
kbdio: RESET_KBD return code:00fa
kbdio: RESET_KBD status:00aa
sc0 at 0x60-0x6f irq 1 on motherboard
sc0: BIOS video mode:3
sc0: VGA registers upon power-up
50 18 10 00 10 00 03 00 02 67 60 4f 50 83 55 81
bf 1f 00 4f 0e 0f 00 00 07 80 9c 8e 8f 28 1f 96
b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c
3d 3e 3f 0c 00 0f 08 00 00 00 00 00 10 0e 00 ff
sc0: video mode:24
sc0: VGA registers in BIOS for mode:24
50 18 10 00 10 00 03 00 02 67 60 4f 50 83 55 81
bf 1f 00 4f 0d 0e 00 00 00 00 9c 8e 8f 28 1f 96
b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c
3d 3e 3f 0c 00 0f 08 00 00 00 00 00 10 0e 00 ff
sc0: VGA registers to be used for mode:24
50 18 10 00 10 00 03 00 02 67 60 4f 50 83 55 81
bf 1f 00 4f 0d 0e 00 00 00 00 9c 8e 8f 28 1f 96
b9 a3 ff 00 01 02 03 04 05 14 07 38 39 3a 3b 3c
3d 3e 3f 0c 00 0f 08 00 00 00 00 00 10 0e 00 ff
sc0: rows_offset:1
sc0: VGA color <16 virtual consoles, flags=0x0>
sio0: irq maps: 0x1 0x11 0x1 0x1
sio0 at 0x3f8-0x3ff irq 4 on isa
sio0: type 16550A
sio1: irq maps: 0x1 0x9 0x1 0x1
sio1 at 0x2f8-0x2ff irq 3 on isa
sio1: type 16550A
sio2: disabled, not probed.
sio3: disabled, not probed.
lpt0 at 0x378-0x37f irq 7 on isa
lpt0: Interrupt-driven port
lp0: TCP/IP capable interface
bpf: lp0 attached
lpt1 not found at 0xffffffff
psm0: current command byte:0047
kbdio: TEST_AUX_PORT status:0000
kbdio: RESET_AUX return code:00fa
kbdio: RESET_AUX status:00aa
kbdio: RESET_AUX ID:0000
psm: status 00 02 64
psm: status 00 00 64
psm: status 00 03 64
psm: status 00 03 64
psm: status 10 00 64
psm: data 08 00 00
psm: data 08 00 00
psm: status 00 02 64
psm0 at 0x60-0x64 irq 12 on motherboard
psm0: model Generic PS/2 mouse, device ID 0, 2 buttons
psm0: config:00000000, flags:00000000, packet size:3
psm0: syncmask:c0, syncbits:00
mss_detect error, busy still set (0xff)
pcm0 at 0x220 irq 5 drq 1 flags 0x15 on isa
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: FIFO enabled, 8 bytes threshold
fd0: 1.44MB 3.5in
wdc0 at 0x1f0-0x1f7 irq 14 on isa
wdc0: unit 0 (wd0): <FUJITSU MPC3032AT>
wd0: 3093MB (6335280 sectors), 6704 cyls, 15 heads, 63 S/T, 512 B/S
wdc1 at 0x170-0x177 irq 15 on isa
wdc1: unit 0 (atapi): <NEC CD-ROM DRIVE:282/4.62>, removable, dma, iordy
wcd0: 2412/5512Kb/sec, 128Kb cache, audio play, 256 volume levels, ejectable tray
wcd0: medium type unknown, unlocked
npx0 flags 0x1 on motherboard
npx0: INT 16 interface
apm0: disabled, not probed.
imasks: bio c008c040, tty c0071cba, net c0071cba
BIOS Geometries:
0:030f7f3f 0..783=784 cylinders, 0..127=128 heads, 1..63=63 sectors
0 accounted for
Device configuration finished.
Intel Pentium F00F detected, installing workaround
bpf: tun0 attached
bpf: sl0 attached
bpf: ppp0 attached
new masks: bio c008c040, tty c0071cba, net c0071cba
bpf: lo0 attached
Considering FFS root f/s.
wd0s1: type 0xa5, start 63, end = 1636991, size 1636929 : OK
wd0s2: type 0x6, start 1636992, end = 5830271, size 4193280 : OK
Any clues of whats happening ?
--
Peter Håkanson Phone +46 0708 39 23 04
Network Management AB Fax +46 031 779 7844
pub 1024/3D18CE6D 1998/04/03 Peter Hakanson<peter@netman.se>
Key fingerprint = F2 BC E6 DF 8F D5 A2 1D 12 52 4C 1E 12 87 81 20
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-multimedia" in the body of the message
home |
help
Want to link to this message? Use this
URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.3.96.990514104645.4046G-100000>