Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 4 Feb 2014 11:46:46 -0800
From:      "Waitman Gobble" <uzimac@da3m0n8t3r.com>
To:        "Warren Block" <wblock@wonkity.com>
Cc:        freebsd-wireless@freebsd.org, Colin Percival <cperciva@freebsd.org>
Subject:   Re: recommended usb wifi device?
Message-ID:  <4003b2734601ce5f28af2eedd250d4cc.squirrel@mx.waitman.net>
In-Reply-To: <alpine.BSF.2.00.1402041815380.40583@wonkity.com>
References:  <52F16122.9010106@freebsd.org> <CAN48zx=d1tQV-TJQnnQ%2BknvxtMxZZzv5n=1eJOMSsenr6OJQmA@mail.gmail.com> <52F17F60.8040900@da3m0n8t3r.com> <52F18C00.2030706@freebsd.org> <52F18DB5.70407@da3m0n8t3r.com> <alpine.BSF.2.00.1402041815380.40583@wonkity.com>

next in thread | previous in thread | raw e-mail | index | archive | help

On Tue, February 4, 2014 5:30 pm, Warren Block wrote:
> On Tue, 4 Feb 2014, Waitman Gobble wrote:
>
>
>> On 2/4/2014 4:55 PM, Colin Percival wrote:
>>
>>> On 02/04/14 16:01, Waitman Gobble wrote:
>>>
>>>> Ralink is a good choice esp. for USB. You might have trouble using
>>>> other supported chipsets which are connected to the USB port.
>>>>
>>>> Also note that the wireless card in the laptop can be replaced for
>>>> about ten bucks. It's typically the easiest thing to replace in a
>>>> laptop. If you decide to swap out your wifi card I'd recommend
>>>> Atheros.
>>>>
>>>
>>> I considered that, but I've heard rumours about laptop BIOSes
>>> blacklisting wifi cards from other manufacturers, so I figured a USB
>>> device was an easier solution.
>>>
>>
>> That's a potential issue. I've only seen that happen with HP laptops,
>> but you should research before spending the ten bucks.
>
> Lenovo does it too.  So far, I have not encountered an Acer or Dell with
> the problem.  Recent Toshiba models are made by Acer, but I can't recall
> changing the wireless card in one.
>
> Dell often uses Broadcom cards.  It would be nice if the new Broadcom
> partipation in FreeBSD would extend to improving their wireless drivers.
>

Here, here. BC working would be nice indeed. I kind of helped those two
guys when they started. It's possible I fabricated their first 'heartbeat'
out of hmmm 1/4" rod. And the first sets of chasis. And it came back to
cause me problems over the years. :)

Anyway, I haven't noticed that going on with Asus either.

There are documented ways around the stalled boot but none of them are
pretty.


-- 
Waitman Gobble
San Jose California USA
(510) 830-7975



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?4003b2734601ce5f28af2eedd250d4cc.squirrel>