Date: Fri, 29 Mar 2002 09:53:02 +0100 (=?ISO-8859-1?Q?Westeurop=E4ische_Normalzeit?=) From: Lukas Ertl <l.ertl@univie.ac.at> To: "Kenneth D. Merry" <ken@kdm.org> Cc: freebsd-scsi@FreeBSD.ORG Subject: Re: ciss driver and tagged queuing Message-ID: <Pine.WNT.4.43.0203290950180.576-100000@korben> In-Reply-To: <20020328163740.A24032@panzer.kdm.org>
next in thread | previous in thread | raw e-mail | index | archive | help
On Thu, 28 Mar 2002, Kenneth D. Merry wrote:
> Okay, it looks like you should be able to send at least 256 simultaneous
> commands. What does dmesg say about da1 (which I assume is the smart arr=
ay
> device)? (might be faster to just send the full dmesg output)
Here you are:
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.5-STABLE #0: Fri Mar 22 17:38:51 CET 2002
le@raidtest.univie.ac.at:/usr/obj/usr/src/sys/RAIDTEST
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 1125772801 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (1125.77-MHz 686-class CPU)
Origin =3D "GenuineIntel" Id =3D 0x6b1 Stepping =3D 1
Features=3D0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CM=
OV,PA
T,PSE36,MMX,FXSR,SSE>
real memory =3D 1342160896 (1310704K bytes)
avail memory =3D 1302265856 (1271744K bytes)
pnpbios: Bad PnP BIOS data checksum
Preloaded elf kernel "kernel" at 0xc02d2000.
Pentium Pro MTRR support enabled
md0: Malloc disk
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib1: <ServerWorks host to PCI bridge> on motherboard
pci1: <PCI bus> on pcib1
pcib0: <ServerWorks host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
ciss0: <Compaq Smart Array 5i> port 0x2000-0x20ff mem
0xf5ef0000-0xf5ef3fff,0xf7
cc0000-0xf7cfffff irq 3 at device 1.0 on pci0
ciss0: using 256 of 1024 available commands
ciss0: 1 logical drive configured
ciss0: firmware 1.42
ciss0: 2 SCSI channels
ciss0: signature 'CISS'
ciss0: valence 1
ciss0: supported I/O methods 0xe<simple,performant,MEMQ>
ciss0: active I/O method 0x3<simple>
ciss0: 4G page base 0x00000000
ciss0: interrupt coalesce delay 1000us
ciss0: interrupt coalesce count 16
ciss0: max outstanding commands 1024
ciss0: bus types 0x2<ultra3>
ciss0: server name ''
ciss0: heartbeat 0x10000032
ciss0: 1 logical drive
ciss0: logical drive 0: RAID 1, 16896MB online
fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0x2400-0x243f mem
0xf7b00000-0xf7bf
ffff,0xf7cb0000-0xf7cb0fff irq 5 at device 2.0 on pci0
fxp0: Ethernet address 00:02:a5:f0:bd:02
inphy0: <i82555 10/100 media interface> on miibus0
inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
fxp1: <Intel Pro 10/100B/100+ Ethernet> port 0x2440-0x247f mem
0xf7900000-0xf79f
ffff,0xf7af0000-0xf7af0fff irq 7 at device 4.0 on pci0
fxp1: Ethernet address 00:02:a5:f0:bd:01
inphy1: <i82555 10/100 media interface> on miibus1
inphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pci0: <ATI Mach64-GR graphics accelerator> at 5.0
pci0: <unknown card> (vendor=3D0x0e11, dev=3D0xa0f0) at 6.0 irq 10
isab0: <ServerWorks IB6566 PCI to ISA bridge> at device 15.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <ServerWorks ROSB4 ATA33 controller> port 0x2c00-0x2c0f at device
15.1
on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <OHCI USB controller> at 15.2 irq 11
pcib2: <ServerWorks host to PCI bridge> on motherboard
pci2: <PCI bus> on pcib2
pcib7: <ServerWorks host to PCI bridge> on motherboard
pci7: <PCI bus> on pcib7
ciss1: <Compaq Smart Array 5300> port 0x3000-0x30ff mem
0xf7e00000-0xf7efffff,0x
f7fc0000-0xf7ffffff irq 3 at device 4.0 on pci7
ciss1: using 256 of 1024 available commands
ciss1: 1 logical drive configured
ciss1: firmware 1.76
ciss1: 2 SCSI channels
ciss1: signature 'CISS'
ciss1: valence 1
ciss1: supported I/O methods 0xe<simple,performant,MEMQ>
ciss1: active I/O method 0x3<simple>
ciss1: 4G page base 0x00000000
ciss1: interrupt coalesce delay 1000us
ciss1: interrupt coalesce count 0
ciss1: max outstanding commands 1024
ciss1: bus types 0x2<ultra3>
ciss1: server name ''
ciss1: heartbeat 0x20000022
ciss1: 1 logical drive
ciss1: logical drive 0: RAID 5, 416768MB online
pci7: <unknown card> (vendor=3D0x0e11, dev=3D0xa0f7) at 7.0 irq 15
eisa0: <EISA bus> on motherboard
mainboard0: <CPQ071a (System Board)> on eisa0 slot 0
orm0: <Option ROMs> at iomem
0xc0000-0xc7fff,0xc8000-0xcbfff,0xcc000-0xcffff,0xd
0000-0xd17ff,0xee000-0xeffff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model IntelliMouse, device ID 3
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=3D0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: parallel port not found.
acd0: CDROM <CRN-8245B> at ata0-master PIO4
da1 at ciss1 bus 0 target 0 lun 0
da1: <RAID 5 OK > Fixed Direct Access SCSI-0 device
da1: 135.168MB/s transfers
da1: 416780MB (853565580 512 byte sectors: 255H 32S/T 39067C)
da0 at ciss0 bus 0 target 0 lun 0
da0: <RAID 1 OK > Fixed Direct Access SCSI-0 device
da0: 135.168MB/s transfers
da0: 17359MB (35553120 512 byte sectors: 255H 32S/T 4357C)
regards,
le
--=20
Lukas Ertl eMail: l.ertl@univie.ac.at
UNIX-Systemadministrator Tel.: (+43 1) 4277-14073
Zentraler Informatikdienst (ZID) Fax.: (+43 1) 4277-9140
der Universit=E4t Wien http://mailbox.univie.ac.at/~le/
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-scsi" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.WNT.4.43.0203290950180.576-100000>