Date: Thu, 25 Feb 1999 22:15:48 -0500 (EST) From: Patrick Seal <patseal@hyperhost.net> To: mobile@freebsd.org, freebsd-questions@freebsd.org Subject: PCCARD modem trouble (fwd) Message-ID: <Pine.BSF.4.05.9902252201300.9630-100000@foobar.hyperhost.net>
next in thread | raw e-mail | index | archive | help
This is a second post, (with minor revisions) If I receive no reply
this time I'll post no more on this problem.
Thanks for all your past help!
I have a Dell Lattitude CPi with a docking station and a 3COM
3CCM156 modem.
If I'm not docked I can use the modem, when I am docked it complains:
driver allocation failed for 3COM
This is a dmesg diff:
--- nodock Sat Feb 20 11:44:30 1999
+++ dock Sat Feb 20 11:41:38 1999
@@ -18,6 +18,9 @@
chip1: <Intel 82371AB PCI to ISA bridge> rev 0x01 on pci0.7.0
ide_pci0: <Intel PIIX4 Bus-master IDE controller> rev 0x01 on pci0.7.1
chip2: <Intel 82371AB Power management controller> rev 0x01 on pci0.7.3
+xl0: <3Com 3c905 Fast Etherlink XL 10/100BaseTX> rev 0x00 int a irq 10 on
pci0.13.0
+xl0: Ethernet address: 00:c0:4f:ef:2c:5d
+xl0: autoneg complete, link status good (half-duplex, 10Mbps)
Probing for PnP devices:
Probing for devices on the ISA bus:
sc0 on isa
@@ -62,4 +65,3 @@
PC-Card VLSI 82C146 (5 mem & 2 I/O windows)
pcic: controller irq 9
Card inserted, slot 2
-sio2: type 16550A
The pccard.conf has irq 10 as the default for the modem. I change it to 8
(to avoid conflict with xl0) and it won't work docked or undocked, even
thouth the dumpcis seems to say it should work with irq 8.
here is pccardc dumpcis:
Code 128 not found
Code 128 not found
code Unknown ignored
Code 131 not found
Code 131 not found
code Unknown ignored
Configuration data for card in slot 0
Tuple #1, code = 0x1 (Common memory descriptor), length = 3
000: 00 00 ff
Common memory device information:
Device number 1, type No device, WPS = OFF
Speed = No speed, Memory block size = 512b, 1 units
Tuple #2, code = 0x15 (Version 1 info), length = 41
000: 04 01 33 43 4f 4d 00 33 43 43 4d 31 35 36 00 35
010: 36 4b 20 47 6c 6f 62 61 6c 20 4d 6f 64 65 6d 20
020: 50 43 20 43 61 72 64 00 ff
Version = 4.1, Manuf = [3COM],card vers = [3CCM156]
Addit. info = [56K Global Modem PC Card],[]
Tuple #3, code = 0x20 (Manufacturer ID), length = 4
000: 01 01 39 00
PCMCIA ID = 0x101, OEM ID = 0x39
Tuple #4, code = 0x21 (Functional ID), length = 2
000: 02 01
Serial port/modem - POST initialize
Tuple #5, code = 0x1a (Configuration map), length = 5
000: 01 23 00 03 03
Reg len = 2, config register addr = 0x300, last config = 0x23
Registers: XX------
Tuple #6, code = 0x1b (Configuration entry), length = 16
000: e0 41 99 49 55 3e 3d aa 60 f8 03 07 30 ff ff 28
Config index = 0x20(default)
Interface byte = 0x41 (I/O) +RDY/-BSY active
Vcc pwr:
Nominal operating supply voltage: 5 x 1V
Continuous supply current: 3.5 x 100mA
Power down supply current: 3.5 x 10mA
Card decodes 10 address lines, 8 Bit I/O only
I/O address # 1: block start = 0x3f8 block length = 0x8
IRQ modes: Level
IRQs: 4 5 8 9 10 11 12 13 14 15
Max twin cards = 0
Misc attr: (Audio-BVD2) (Power down supported)
Tuple #7, code = 0x1b (Configuration entry), length = 7
000: 21 08 aa 60 f8 02 07
Config index = 0x21
Card decodes 10 address lines, 8 Bit I/O only
I/O address # 1: block start = 0x2f8 block length = 0x8
Tuple #8, code = 0x1b (Configuration entry), length = 7
000: 22 08 aa 60 e8 03 07
Config index = 0x22
Card decodes 10 address lines, 8 Bit I/O only
I/O address # 1: block start = 0x3e8 block length = 0x8
Tuple #9, code = 0x1b (Configuration entry), length = 7
000: 23 08 aa 60 e8 02 07
Config index = 0x23
Card decodes 10 address lines, 8 Bit I/O only
I/O address # 1: block start = 0x2e8 block length = 0x8
Tuple #10, code = 0x22 (Functional EXT), length = 4
000: 00 02 0f 7c
Serial interface extension:
16550 UART, Parity - Space,Mark,Odd,Even,
Tuple #11, code = 0x22 (Functional EXT), length = 9
000: 01 1f 0f 00 06 00 00 06 00
Modem interface capabilities:
Tuple #12, code = 0x22 (Functional EXT), length = 12
000: 02 06 00 3f 1c 03 03 0f 07 00 02 b5
Data modem services available:
Tuple #13, code = 0x22 (Functional EXT), length = 8
000: 13 06 00 0f 00 02 00 b5
Tuple #14, code = 0x22 (Functional EXT), length = 8
000: 23 06 00 0f 00 02 00 b5
Tuple #15, code = 0x0 (Null tuple), length = 10
000: 02 01 39 00 a1 00 01 00 00 ff
Tuple #16, code = 0x0 (Null tuple), length = 14
000: 31 30 38 56 31 39 34 38 34 47 55 44 00 ff
Tuple #17, code = 0x14 (No link), length = 0
Tuple #18, code = 0xff (Terminator), length = 0
2 slots found
Thanks!
------------------------------------ _____________________________________
Patrick Seal |"Microsoft isn't evil, they just make
<patseal@hyperhost.net> | really crappy operating systems."
Hyperhost - http://www.hyperhost.net| -Linus Torvalds
hosting and Design
http://www.freebsd.org - http://www.linux.org
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.05.9902252201300.9630-100000>