Date: Thu, 1 Jun 2000 18:37:32 +0200 (CEST) From: luigi@info.iet.unipi.it To: fred@veriohosting.com Cc: freebsd-hackers@FreeBSD.ORG, freebsd-stable@FreeBSD.ORG Subject: Re: changed pci bus probe order from 3.2 to 4.0 -- ideas? Message-ID: <NZ7edb1f-7da447bc@custserv.com>
next in thread | raw e-mail | index | archive | help
...
> The problem is that the cards get swapped.
...
> It's a long story as to why switching cables, or changing which card gets
> which IP address isn't really a good solution. The short answer is that
i suppose the only place where you use the actual card names
is the firewall config and rc.conf -- can't you just make these
scripts fetch the ethernet address of the card(s), set a shell
variable with the name of the good card, and go ahead with that ?
I did something similar in picobsd to make the same floppy recognise
the hardware on different systems. Something like (in /etc/rc):
n_ether=""
for main_if in `ifconfig -l` ; do
set `ifconfig $main_if`
while [ "$1" != "" ] ; do
if [ $1 = "ether" ] ; then
main_ether=$2
break 2
else
shift
fi
done
done
At which point $main_ether contains the ethernet address of your
first ethernet interface and you can base decisions on that...
cheers
luigi
-----------------------------------+-------------------------------------
Luigi RIZZO, luigi@iet.unipi.it . Dip. di Ing. dell'Informazione
http://www.iet.unipi.it/~luigi/ . Universita` di Pisa
TEL/FAX: +39-050-568.533/522 . via Diotisalvi 2, 56126 PISA (Italy)
Mobile +39-347-0373137
-----------------------------------+-------------------------------------
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?NZ7edb1f-7da447bc>