Date: Sun, 27 Nov 2005 23:48:18 -0500 From: Anthony Mattke <a.mattke@gmail.com> To: freebsd-questions@freebsd.org Subject: pc cards on watchguard firebox II Message-ID: <2b9aedcc0511272048k7fd32194m4badb675916fe736@mail.gmail.com>
next in thread | raw e-mail | index | archive | help
I have a WatchGuard Firebox II that I've been working on turning into a decent router. I see many people have installed monowall (http://m0n0.ch/wall/) on these boxes with good success. I would be done myself unless I was setting up a wireless bridge. These boxes are basicly custom pentium 200's with 3 ethernet ports, a few serial ports, 2 pcmcia card slots, a 44pin ide header, a keyboard header, and 2 backwards facing pci slots. The problem I am having is with getting a pc card to be detected, it knows they're there, it just wont register them. First off, I'm new to BSD. Second, I know this is not straight up BSD, but if given direction I can make anything happen that needs to for testing, I have a 5.3 box setup for testing, altho I'm having trouble getting it to boot on the firebox ( i need to recompile and disabe psm0 detection) Anyway, this is what I'm seeing. pci_cfgintr: can't route an interrupt to 0:16 INTA pcic0: <TI PCI-1225 PCI-CardBus Bridge> at device 16.0 on pci0 pcic0: PCI Memory allocated: 0x88000000 pci_cfgintr: can't route an interrupt to 0:16 INTA pcic0: No PCI interrupt routed, trying ISA. pcic0: Polling mode pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][CSC serial isa irq] pccard0: <PC Card 16-bit bus (classic)> on pcic0 pci_cfgintr: can't route an interrupt to 0:16 INTB pcic1: <TI PCI-1225 PCI-CardBus Bridge> at device 16.1 on pci0 pcic1: PCI Memory allocated: 0x88001000 pci_cfgintr: can't route an interrupt to 0:16 INTB pcic1: No PCI interrupt routed, trying ISA. pcic1: Polling mode pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][CSC serial isa irq] pccard1: <PC Card 16-bit bus (classic)> on pcic1 pmtimer0 on isa0 I've google'd and google'd and poked and prodded, I've added the following to /boot/loader.conf, with no success. hint.acpi.0.disabled=3D1 hw.cbb.start_memory=3D0x20000000 If you want a look at the kernel config it is located here. (this is for monowall, not my 5.3 box, that has yet to be recompiled) http://m0n0.ch/wall/downloads/freeb...0N0WALL_GENERIC Any suggestions on where to go next? If you need any output, or anything, let me know. Thanks in advance, Tony
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?2b9aedcc0511272048k7fd32194m4badb675916fe736>