Date: Wed, 29 Dec 2010 03:10:59 +0800 (SGT) From: Darmawan Salihun <darmawan_salihun@yahoo.com> To: John Baldwin <jhb@freebsd.org> Cc: freebsd-hackers@freebsd.org Subject: Re: PCI IDE Controller Base Address Register setting Message-ID: <964892.49841.qm@web76809.mail.sg1.yahoo.com> In-Reply-To: <201012281352.31367.jhb@freebsd.org>
index | next in thread | previous in thread | raw e-mail
Hi, --- On Tue, 12/28/10, John Baldwin <jhb@freebsd.org> wrote: > From: John Baldwin <jhb@freebsd.org> > Subject: Re: PCI IDE Controller Base Address Register setting > To: "Darmawan Salihun" <darmawan_salihun@yahoo.com> > Cc: freebsd-hackers@freebsd.org > Date: Tuesday, December 28, 2010, 1:52 PM > On Tuesday, December 28, 2010 1:38:05 > pm Darmawan Salihun wrote: > > Hi, > > > > --- On Tue, 12/28/10, John Baldwin <jhb@freebsd.org> > wrote: > > > > > From: John Baldwin <jhb@freebsd.org> > > > Subject: Re: PCI IDE Controller Base Address > Register setting > > > To: freebsd-hackers@freebsd.org > > > Cc: "Darmawan Salihun" <darmawan_salihun@yahoo.com> > > > Date: Tuesday, December 28, 2010, 10:20 AM > > > On Monday, December 27, 2010 6:07:35 > > > am Darmawan Salihun wrote: > > > > Hi, > > > > > > > > I'm trying to install FreeBSD 8.0 on AMD > Geode LX800 > > > (CS5536 "southbridge"). > > > However, it cannot detect the IDE controller (in > the > > > CS5536) correctly. It > > > says something similar to this: > > > > "IDE controller not present" > > > > > > Hmm, I can't find a message like that > anywhere. Can > > > you get the exact message > > > you are seeing? > > > > > > > It says: > > > > "No disks found! Please verify that your disk > controller is being properly > > probed at boot time." > > Oh, so this is a message from the installer. Can you > capture a verbose dmesg > via a serial console perhaps? I'm not sure if I can do this because I've tried a couple of times but nothing comes out of the serial console. Perhaps a wrong baud rate setting? I set it to 96bps and 8-N-1 back then. Is that correct? > Or at least the kernel > probe messages for your > ATA controller? > I recall that pressing Alt+F2 during the installation would open-up another console, full with log messages. Would that be enough? Thanks, Darmawan > -- > John Baldwin > _______________________________________________ > freebsd-hackers@freebsd.org > mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-hackers > To unsubscribe, send any mail to "freebsd-hackers-unsubscribe@freebsd.org" >help
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?964892.49841.qm>