Date: Wed, 22 Jan 2014 15:33:23 +0000 From: Alexey Dokuchaev <danfe@FreeBSD.org> To: powerpc@FreeBSD.org Subject: Tightening kernel for Mac Mini G4 Message-ID: <20140122153323.GA3637@FreeBSD.org>
next in thread | raw e-mail | index | archive | help
Hi there, Today I've brought to life an old rusted Mac Mini G4 which was almost thrown into the garbage. I've just installed some fresh snapshot of -CURRENT on it, and now building world. Before I get to the kernel stage, I have couple of questions (to minimize the chances of hooking up console again if I screw up along the way). I'm used to trimming the kernel config down as much as possible (yes, that means "nodevice mem" and "nodevice io" at least on i386). This brings me to the first question: do I read it correctly that "device io" is x86 specific and I don't need it on ppc? Second question is about ATA subsystem. Per dmesg(8): ata0: <Apple MacIO ATA Controller> mem 0x20000-0x20fff,0x8800-0x88ff irq 24,12 on macio0 ata1: <Intrepid Kauai ATA Controller> mem 0xf5004000-0xf5007fff irq 39 at device 13.0 on pci2 ada0 at ata1 bus 0 scbus1 target 0 lun 0 ada0: <TOSHIBA MK4025GAS KA100P> ATA-6 deviceuhub1: 3 ports with 3 removable, self powered Normally on x86 I omit ATA stuff completely from kernel config, and just add ataintel_load="YES" (on pre-AHCI system) in /boot/loader.conf, which in turn loads all necessary dependencies (atapci.ko, etc.). Since "ataintel" hardly applies to my G4: 1) can I remove ATA from my MACMINI kernel config?, and 2) what shall I add to /boot/loader.conf to enable the disk in Mac Mini G4? Is atapci.ko (or simply ata.ko) enough? I do not see MacIO- or Kauai-related .ko files under /boot/kernel, hence the question. Third, about this section of powerpc/GENERIC, seemingly PowerPC-related: device iicbus # I2C bus code device kiic # Keywest I2C device ad7417 # PowerMac7,2 temperature sensor device ds1631 # PowerMac11,2 temperature sensor device ds1775 # PowerMac7,2 temperature sensor device fcu # Apple Fan Control Unit device max6690 # PowerMac7,2 temperature sensor device powermac_nvram # Open Firmware configuration NVRAM ^^^^^^^^^^^^^^ How is this one related to nvram.ko? Do I need to add nvram_load="YES" to /boot/loader.conf to be able to interact with OF nvram from userland? Do I have to keep "powermac_nvram" in kernel config at the same time? device smu # Apple System Management Unit device windtunnel # Apple G4 MDD fan controller None of these seems to be modularized, so: which of them are required for Mac Mini G4? Fourth question is of less importance, but still. In powerpc/GENERIC, I see this sound support section: device sound # Generic sound driver (required) device snd_ai2s # Apple I2S audio device snd_davbus # Apple DAVBUS audio device snd_uaudio # USB Audio But nonetheless: $ mixer mixer: /dev/mixer: No such file or directory Is internal sound card supported? If yes, which module should I load? Thanks, ./danfe
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20140122153323.GA3637>