Date: Fri, 23 May 1997 08:50:44 -0700 (PDT) From: patl@phoenix.volant.org To: jgrosch@superior.mooseriver.com Cc: hackers@freebsd.org Subject: Re: SCSI tape config Message-ID: <ML-3.3.864402644.7515.patl@asimov> In-Reply-To: <199705222322.QAA15372@superior.mooseriver.com>
next in thread | previous in thread | raw e-mail | index | archive | help
> I've got this old Wangtek tape drive that handles QIC-150 tapes. THis drive > came out of an old Sun shoebox and has an adapter board to allow a SCSI > controller to driver it. My question is how does one set the SCSI id. There > are a number of jumpers on the adapter board, which was made by > Emulex. Does anyone know anthing about these? If this is one of the older shoeboxes, with the separate SCSI adapter board, it is probably a 60Mb tape with the Emulex MT02 SCSI adapter. The MT02 has a DIP switch module with switch 1 nearest the edge of the board. The switches are: Switch Setting Description 1 off SCSI target bit 0 2 off SCSI target bit 1 3 on SCSI target bit 2 4 off Not used 5,6 on,off Archive Scorpion Drive 5,6 on,on Wangtek 5000E Drive 7 off Drive type 8 off SCSI bus parity check The general board layout is: +------------------------------------+ | :::::J3::::: ::J2:: ::J1:: | | .1. | | E .2. | | F .3. | | SW1 | | G .5. | | H .6. | | .7. | | .8. | | Off On| ... | +-+ +-+ | | | | Terminator Terminator | | | | | | U46 U5 | | | | +-+ C | | D | | :::::SCSI::::: 0 0 [PWR] | +-------1:::::::::::::---------------+ LEDs -Pat
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?ML-3.3.864402644.7515.patl>