Date: Fri, 14 Apr 2000 16:17:06 +0200 (SAST) From: fingers <fingers@fingers.co.za> To: "Sean O'Connell" <sean@stat.Duke.EDU> Cc: freebsd-stable@freebsd.org Subject: Re: problem with ata/ad0 in 4.0 Message-ID: <Pine.BSF.3.96.1000414160910.1130L-100000@fingers.noc.uunet.co.za> In-Reply-To: <20000414092434.A17433@stat.Duke.EDU>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi
> You may want to post some dmesg output back to the list. There
> are know issues with ata and certain chipsets (VIA something or
> anothers, old Intel chips, CMD 640, Aztec RZ100?).
<dmesg on 3.4-STABLE>
Copyright (c) 1992-1999 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 3.4-STABLE #10: Wed Mar 29 19:10:01 SAST 2000
root@sticky:/usr/src/sys/compile/STICKY
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 167047048 Hz
CPU: Pentium/P55C (167.05-MHz 586-class CPU)
Origin = "GenuineIntel" Id = 0x543 Stepping = 3
Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory = 67108864 (65536K bytes)
avail memory = 62214144 (60756K bytes)
Preloaded elf kernel "kernel" at 0xc028a000.
Probing for devices on PCI bus 0:
chip0: <Host to PCI bridge (vendor=1039 device=5596)> rev 0x00 on pci0.0.0
chip1: <SiS 85c503> rev 0x01 on pci0.1.0
ide_pci0: <PCI IDE controller (busmaster capable)> rev 0x09 int a irq 14
on pci0.1.1
vga0: <S3 ViRGE DX/GX graphics accelerator> rev 0x01 int a irq 11 on
pci0.11.0
rl0: <RealTek 8139 10/100BaseTX> rev 0x10 int a irq 10 on pci0.15.0
rl0: Ethernet address: 00:c0:df:22:4a:ad
rl0: autoneg complete, link status good (half-duplex, 10Mbps)
vga1: <SiS 86c205 SVGA controller> rev 0x11 on pci0.20.0
Probing for devices on the ISA bus:
sc0 on isa
sc0: VGA color <16 virtual consoles, flags=0x0>
atkbdc0 at 0x60-0x6f on motherboard
atkbd0 irq 1 on isa
sio0 at 0x3f8-0x3ff irq 4 flags 0x10 on isa
sio0: type 16550A
sio1 at 0x2f8-0x2ff irq 3 on isa
sio1: type 16550A
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: FIFO enabled, 8 bytes threshold
wdc0 at 0x1f0-0x1f7 irq 14 on isa
wdc0: unit 0 (wd0): <QUANTUM FIREBALL SE3.2A>
wd0: 3079MB (6306048 sectors), 6256 cyls, 16 heads, 63 S/T, 512 B/S
wdc1 not found at 0x170
ppc0 at 0x378 irq 7 on isa
ppc0: W83877F chipset (NIBBLE-only) in COMPATIBLE mode
ppi0: <generic parallel i/o> on ppbus 0
plip0: <PLIP network interface> on ppbus 0
vga0 at 0x3b0-0x3df maddr 0xa0000 msize 131072 on isa
npx0 on motherboard
npx0: INT 16 interface
Intel Pentium detected, installing workaround for F00F bug
changing root device to wd0s1a
</dmesg>
I can't get a dmesg from the 4.0 installation, it goes past too fast :(
but I did see that it didn't pick up any ata/ad0 devices
> Also, did you
> use bad144 or badblock stuff on this drive (no longer supported
> with ata). You may also need to disable dma.
I actually have no idea about bad144 or badblock. The box came up from
3.1-RELEASE over the last year or so....
> You may also want to search through either dejanews or the stable
> list archives for that error message, you'll get a good bit of
> reading material.
I'll start this now.....
Thanks and regards
--Rob
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.3.96.1000414160910.1130L-100000>