Date: Fri, 27 Sep 2002 22:55:57 +0200 From: Wilko Bulte <wkb@freebie.xs4all.nl> To: FreeBSD-alpha mailing list <freebsd-alpha@freebsd.org> Subject: 4.7-RC1 fails on AlphaStation500/266 Message-ID: <20020927225556.A18638@freebie.xs4all.nl>
index | next in thread | raw e-mail
>>>boot dka600
(boot dka600.6.0.9.0 -flags a)
block 0 of dka600.6.0.9.0 is a valid boot block
reading 368 blocks from dka600.6.0.9.0
bootstrap code read in
base = 14a000, image_start = 0, image_bytes = 2e000
initializing HWRPB at 2000
initializing page table at 13c000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
Console: SRM firmware console
VMS PAL rev: 0x1000000010114
OSF PAL rev: 0x1000000020116
Switch to OSF PAL code succeeded.
FreeBSD/alpha SRM CD9660 boot, Revision 1.0
(root@sema.baldwin.cx, Tue Sep 17 15:05:05 GMT 2002)
Memory: 65536 k
|/-g-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|Loading /boot/defaults/loader.conf
|/-g-
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [kernel] in 9 seconds...
Booting [kernel] in 8 seconds...
Booting [kernel] in 7 seconds...
Booting [kernel] in 6 seconds...
Booting [kernel] in 5 seconds...
Booting [kernel] in 4 seconds...
Booting [kernel] in 3 seconds...
Booting [kernel] in 2 seconds...
Booting [kernel] in 1 second...
Booting [kernel]...
/-g-Entering kernel at 0xfffffc0000335be0...
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.7-RC1 #0: Tue Sep 17 18:27:01 GMT 2002
root@sema.baldwin.cx:/usr/obj/usr/src/sys/GENERIC
AlphaStation 500 or 600 (KN20AA)
Digital AlphaStation 500/266, 266MHz
8192 byte page size, 1 processor.
CPU: EV5 (21164) major=5 minor=0
OSF PAL rev: 0x1000000020116
real memory = 64798720 (63280K bytes)
avail memory = 51445760 (50240K bytes)
Preloaded elf kernel "kernel" at 0xfffffc0000c1c000.
Preloaded mfs_root "/boot/mfsroot" at 0xfffffc0000c1c0c0.
md0: Preloaded image </boot/mfsroot> 4423680 bytes at 0xfffffc00007e0198
md1: Malloc disk
cia0: ALCOR/ALCOR2, pass 2
pcib0: <2117x PCI host bus adapter> on cia0
pci0: <PCI bus> on pcib0
de0: <Digital 21040 Ethernet> port 0x10180-0x101ff mem 0x80059080-0x800590ff irq 13 at device 6.0 on pci0
de0: interrupting at CIA irq 13
de0: DEC 21040 [10Mb/s] pass 2.4
de0: address 00:00:f8:22:72:73
de1: <Digital 21140A Fast Ethernet> port 0x10100-0x1017f mem 0x80059000-0x8005907f irq 16 at device 8.0 on pci0
de1: interrupting at CIA irq 16
de1: DEC DE500-AA 21140A [10-100Mb/s] pass 2.0
de1: address 00:00:f8:06:c5:55
de1: enabling Full Duplex 100baseTX port
isp0: <Qlogic ISP 1020/1040 PCI SCSI Adapter> port 0x10000-0x100ff mem 0x80058000-0x80058fff irq 12 at device 9.0 on pci0
isp0: interrupting at CIA irq 12
isab0: <Intel 82375EB PCI-EISA bridge> at device 10.0 on pci0
isa0: <ISA bus> on isab0
pci0: <VGA-compatible display device> at 11.0 irq 0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: interrupting at ISA irq 6
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
atkbd0: interrupting at ISA irq 1
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x0>
mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A, console
sio0: interrupting at ISA irq 4
sio1: reserved for low-level i/o
ppc0: <Parallel port> at port 0x3bc-0x3bf irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
lpt0: <Printer> on ppbus0
lpt0: Polled port
ppi0: <Parallel I/O> on ppbus0
ppc0: interrupting at ISA irq 7
Timecounter "alpha" frequency 266671544 Hz
Waiting 15 seconds for SCSI devices to settle
de0: autosense failed: cable problem?
Mounting root from ufs:/dev/md0c
WARNING: clock gained 10 days -- CHECK AND RESET THE DATE!
cd0 at isp0 bus 0 target 6 lun 0
cd0: <DEC RRD46 (C) DEC 0557> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 8)
cd0: cd present [395976 x 512 byte records]
da1 at isp0 bus 0 target 1 lun 0
da1: <IBM DDRS-34560W S97B> Fixed Direct Access SCSI-2 device
da1: 20.000MB/s transfers (10.000MHz, offset 8, 16bit), Tagged Queueing Enabled
da1: 4357MB (8925000 512 byte sectors: 255H 63S/T 555C)
da0 at isp0 bus 0 target 0 lun 0
da0: <IBM DDRS-34560D DC2G> Fixed Direct Access SCSI-2 device
da0: 20.000MB/s transfers (10.000MHz, offset 8, 16bit), Tagged Queueing Enabled
da0: 4303MB (8813870 512 byte sectors: 255H 63S/T 548C)
/stand/sysinstall running as init on serial console
These are the predefined terminal types available to
sysinstall when running stand-alone. Please choose the
closest match for your particular terminal.
1 ...................... Standard ANSI terminal.
2 ...................... VT100 or compatible terminal.
3 ...................... FreeBSD system console (color).
4 ...................... FreeBSD system console (monochrome).
5 ...................... xterm terminal emulator.
Your choice: (1-5) 2
[1;24r [m [?7h[?1h=
fatal kernel trap:
trap entry = 0x2 (memory management fault)
a0 = 0xfffffe00004fe198
a1 = 0x1
a2 = 0x0
pc = 0xfffffc00003ed814
ra = 0xfffffc00003ed7b8
curproc = 0xfffffe0003809cc0
pid = 1, comm = sysinstall
panic: trap
syncing disks...
done
Uptime: 50s
Automatic reboot in 15 seconds - press a key on the console to abort
Rebooting...
halted CPU 0
halt code = 5
HALT instruction executed
PC = fffffc0000629b70
CPU 0 booting
--
| / o / /_ _ wilko@FreeBSD.org
|/|/ / / /( (_) Bulte Arnhem, the Netherlands
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message
help
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20020927225556.A18638>