Date: Sun, 28 Sep 2008 03:29:29 -0600 (MDT) From: "M. Warner Losh" <imp@bsdimp.com> To: mav@freebsd.org Cc: freebsd-arm@freebsd.org, freebsd-current@freebsd.org, freebsd-mobile@freebsd.org Subject: Re: RFC: PCI SD host controller driver & mmc/mmcsd modules improvements Message-ID: <20080928.032929.-1264103837.imp@bsdimp.com> In-Reply-To: <48DEA8E7.2080503@FreeBSD.org>
index | next in thread | previous in thread | raw e-mail
In message: <48DEA8E7.2080503@FreeBSD.org>
Alexander Motin <mav@FreeBSD.org> writes:
: Hi.
:
: I would like to present initial revision of my generic PCI SD Host
: Controller driver (sdhci). It support PCI devices with class 8 and
: subclass 5 according to SD Host Controller Specification. With some
: limitations it successfully works on my Acer TM6292 notebook with ENE
: CB714 card reader.
:
: Things that are working now:
: - PIO mode single and multiple block read and write,
: - 1 and 4 bits bus width support.
:
: In PIO mode with 4GB SD card on 30MHz 4bit bus I have reached about
: 3.5MB/s (limited by CPU) linear read and 7MB/s (limited by card) linear
: write. Small blocks read/write performance limited by card.
:
: Things that are not working yet:
: - DMA modes (code is written, but as my controller looks like has
: broken DMA I have no ability to debug it),
: - card insert/remove detection (need more thinking), you should reload
: mmc module to rescan cards,
: - SDHC and MMC cards (have no such cards now to debug that code), only
: standard capacity SD Memory cards up to 4GB size are supported now,
: - high speed (double rate) bus mode (need more thinking and DMA support).
:
: Also to get such results I have improved existing mmc and mmcsd drivers
: a bit. mmc driver got:
: - 4 bit bus width support,
: - write protection switch support,
: - cards with more then 2GB capacity support.
: mmcsd driver got:
: - multiple block read and write support,
: - cards with more then 2GB capacity support,
: - I/O error reporting,
: - write protection switch support.
:
: Latest patches against 8-CURRENT (should also fit 7-STABLE) may be found at:
: http://people.freebsd.org/~mav/sdhci/
:
: I will be grateful for any feedbacks, comments and support.
I'll take a look at the driver and post a code review...
Warner
home |
help
Want to link to this message? Use this
URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20080928.032929.-1264103837.imp>