Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 31 Jan 2002 11:14:02 -0800 (PST)
From:      Jamie Bowden <ragnar@sysabend.org>
To:        mobile@FreeBSD.org
Subject:   4.5-STABLE on Dell Latitude C810
Message-ID:  <Pine.BSF.4.10.10201311059050.71126-100000@moo.sysabend.org>

next in thread | raw e-mail | index | archive | help

I've recently added a Latitude C810 to our little fleet of Dells and I'd
just like to share.  Good job guys, I installed FreeBSD 4.5-R from CD
yesterday, CVSup'd to -stable last night, and made the world this morning.

All the hardware is recognized and functioning except for the 1394
controller, which FreeBSD has no driver for currently, and the 3Com
Mini-PCI winmodem, which also lacks a driver.  This was fully expected and
completely unsurprising.  The only real down is the GeForce2GO isn't yet
supported in XFree86, which isn't FreeBSD's fault either, just another
data point.

It looks like the IR port is recognized as sio1, which was a pleasant
surprise, as I didn't expect it to work.

Here's a dmesg for any who care:

2:01pm ghast  /home/jamie %dmesg 
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 4.5-STABLE #0: Thu Jan 31 09:55:09 EST 2002
    root@ghast.wdc.photon.com:/usr/src/sys/compile/ghast
Timecounter "i8254"  frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (1129.57-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x6b1  Stepping = 1

Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory  = 536780800 (524200K bytes)
avail memory = 519127040 (506960K bytes)
Preloaded elf kernel "kernel" at 0xc0320000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc032009c.
Preloaded elf module "snd_maestro3.ko" at 0xc03200ec.
Preloaded elf module "snd_pcm.ko" at 0xc0320190.
VESA: v3.0, 32768k memory, flags:0x1, mode table:0xc02a7202 (1000022)
VESA: NVidia
Pentium Pro MTRR support enabled
Using $PIR table, 10 entries at 0xc00fbc20
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
agp0: <Intel Generic host to PCI bridge> mem 0xe8000000-0xebffffff at
device 0.0 on pci0
pcib1: <Intel 82801BA/BAM (ICH2) PCI-PCI (AGP) bridge> at device 1.0 on
pci0
pci1: <PCI bus> on pcib1
pci1: <NVidia model 0112 graphics accelerator> at 0.0 irq 11
pcib2: <PCI to PCI bridge (vendor=8086 device=2448)> at device 30.0 on
pci0
pci2: <PCI bus> on pcib2
pcm0: <ESS Technology Maestro3> port 0xec00-0xecff mem
0xf8ffe000-0xf8ffffff irq 5 at device 3.0 on pci2
xl0: <3Com 3c556 Fast Etherlink XL> port 0xe800-0xe8ff mem
0xf8ffd800-0xf8ffd87f,0xf8ffdc00-0xf8ffdc7f irq 10 at device 6.0 on pci2
xl0: Ethernet address: 00:04:76:4c:0d:94
miibus0: <MII bus> on xl0
ukphy0: <Generic IEEE 802.3u media interface> on miibus0
ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pci2: <unknown card> (vendor=0x10b7, dev=0x1007) at 6.1 irq 10
pcic0: <TI PCI-4451 PCI-CardBus Bridge> irq 10 at device 15.0 on pci2
pcic0: PCI Memory allocated: 0x44000000
pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][CSC serial isa
irq]
pccard0: <PC Card bus (classic)> on pcic0
pcic1: <TI PCI-4451 PCI-CardBus Bridge> irq 10 at device 15.1 on pci2
pcic1: PCI Memory allocated: 0x44001000
pcic1: TI12XX PCI Config Reg: [ring enable][speaker enable][CSC serial isa
irq]
pccard1: <PC Card bus (classic)> on pcic1
pci2: <unknown card> (vendor=0x104c, dev=0x8027) at 15.2 irq 10
isab0: <PCI to ISA bridge (vendor=8086 device=244c)> at device 31.0 on
pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH2 ATA100 controller> port 0xbfa0-0xbfaf at device 31.1
on pci0
ata0: at 0x1f0 irq 14 on atapci0
uhci0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> port 0xdce0-0xdcff
irq 10 at device 31.2 on pci0
usb0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
orm0: <Option ROMs> at iomem
0xc0000-0xccfff,0xcd000-0xcd7ff,0xcd800-0xcdfff,0xce000-0xce7ff,0xce800-0xcefff,0xcf000-0xcf7ff,0xcf800-0xcffff,0xd0000-0xd07ff
on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <8 virtual consoles, flags=0x200>
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
joy0 at port 0x201 on isa0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ad0: 28615MB <IC25N030ATDA04-0> [58140/16/63] at ata0-master UDMA100
acd0: CD-RW <Samsung CD-RW/DVD-ROM SN-308B> at ata0-slave using PIO4
Mounting root from ufs:/dev/ad0s3a

Jamie Bowden

-- 
"It was half way to Rivendell when the drugs began to take hold"
Hunter S Tolkien "Fear and Loathing in Barad Dur"
Iain Bowen <alaric@alaric.org.uk>



To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.BSF.4.10.10201311059050.71126-100000>