Skip site navigation (1)Skip section navigation (2)
Date:      Sun, 23 Dec 2001 19:46:20 +0100
From:      "Petr Holub" <hopet@ics.muni.cz>
To:        "Semen A. Ustimenko" <semenu@FreeBSD.org>
Cc:        <freebsd-hackers@FreeBSD.org>
Subject:   RE: tx driver
Message-ID:  <001a01c18be2$1cfbd360$2603fb93@kloboucek>
In-Reply-To: <Pine.BSF.4.21.0112212251370.36511-100000@def.the.net>

index | next in thread | previous in thread | raw e-mail

[-- Attachment #1 --]
Hi!

> 1) ``pciconf -l'' and ``ifconfig tx0'' output, please

Both are attached.

> 2) Could you upgrade to 4.4 or later? There were few changes.
> Particullary, the true AC101 PHY support. You may try to fetch miibus.ko
> and if_tx.ko binaries from 4.4 system, if you don't want to upgrade whole
> system. I hope it will work.

I'll try this and the rest of your suggestions probably on
Dec. 28 since I suffer from lack of time during Xmas :-( Sorry.
I'll give you the mail when I do that.

Petr

================================================================
                            Petr Holub
CESNET z.s.p.o.                       Supercomputing Center Brno
Zikova 2                             Institute of Compt. Science
10200 Praha, CZ                               Masaryk University
Czech Republic                     Botanicka 68a, 60200 Brno, CZ 
e-mail: Petr.Holub@cesnet.cz              phone: +420-5-41512278
                                       e-mail: hopet@ics.muni.cz  
 

[-- Attachment #2 --]
tx0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
	inet 147.251.3.44 netmask 0xffffff00 broadcast 147.251.3.255
	inet6 fe80::2e0:29ff:fe8e:7519%tx0 prefixlen 64 scopeid 0x1 
	ether 00:e0:29:8e:75:19 
	media: autoselect (100baseTX <full-duplex>) status: active
	supported media: autoselect 100baseTX <full-duplex> 100baseTX 10baseT/UTP <full-duplex> 10baseT/UTP 100baseTX <hw-loopback>

[-- Attachment #3 --]
agp0@pci0:0:0:	class=0x060000 card=0x00000000 chip=0x30991106 rev=0x00 hdr=0x00
pcib1@pci0:1:0:	class=0x060400 card=0x00000080 chip=0xb0991106 rev=0x00 hdr=0x01
tx0@pci0:6:0:	class=0x020000 card=0xa02010b8 chip=0x000510b8 rev=0x09 hdr=0x00
none0@pci0:7:0:	class=0x040000 card=0x035013ec chip=0x612011de rev=0x03 hdr=0x00
bktr0@pci0:8:0:	class=0x040000 card=0x00031461 chip=0x036e109e rev=0x02 hdr=0x00
none1@pci0:8:1:	class=0x048000 card=0x00031461 chip=0x0878109e rev=0x02 hdr=0x00
pcm0@pci0:9:0:	class=0x040100 card=0x80271102 chip=0x00021102 rev=0x08 hdr=0x00
emujoy0@pci0:9:1:	class=0x098000 card=0x00201102 chip=0x70021102 rev=0x08 hdr=0x00
isab0@pci0:17:0:	class=0x060100 card=0x30741106 chip=0x30741106 rev=0x00 hdr=0x00
atapci0@pci0:17:1:	class=0x01018a card=0x05711106 chip=0x05711106 rev=0x06 hdr=0x00
uhci0@pci0:17:2:	class=0x0c0300 card=0x12340925 chip=0x30381106 rev=0x18 hdr=0x00
uhci1@pci0:17:3:	class=0x0c0300 card=0x12340925 chip=0x30381106 rev=0x18 hdr=0x00
uhci2@pci0:17:4:	class=0x0c0300 card=0x12340925 chip=0x30381106 rev=0x18 hdr=0x00
none2@pci1:0:0:	class=0x030000 card=0x0641102b chip=0x0525102b rev=0x82 hdr=0x00
help

Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?001a01c18be2$1cfbd360$2603fb93>