Date: Wed, 16 Apr 1997 20:39:21 -0700 From: Ludwig Pummer <ludwigp@sns.com> To: questions@freebsd.org Subject: Yet another booting problem Message-ID: <3.0.32.19970416203623.00818810@mail.sns.com>
next in thread | raw e-mail | index | archive | help
I did something rather stupid recently, and now FreeBSD won't boot up normally anymore. What did I do? MAKEDEV all. I thought it was going to create all devices referenced in my kernel config, but apparently, it didn't. So now when I boot up, it defaults to booting from wd(0,a)/kernel, then proceeds after checking my hardware proceeds to tell me that it can't find any of my other slices. Startup messages: swapon /dev/wd0s4b : No such file or directory /dev/wd0s4f : No such file or directory can't stat /dev/wd0s4f Then it says it can't find the shell, and asks if it should load sh. I do that, and take a look around. My /usr, /proc, and /var slices aren't loaded. My fstab file (minus the last few columns) is: #Device Mountpoint FStype /dev/wd0s4b none swap /dev/wd0a / ufs /dev/wd0s4f /usr ufs /dev/wd0s4e /var ufs proc /proc procfs /dev/wcd0c /cdrom cd9660 Shouldn't /dev/wd0a be /dev/wd0s4a? I went into /dev and looked in there. The wd0 devices are: wd0, wd0a through wd0h, and wd0s1 through wd0s4. My wd0s4a-s4h devices are gone! But I can't recreate them. If I do MAKEDEV wd0s4a, I get wd0s4: read-only filesystem rwd0s4: read-only filesystem mknod: wd0s4: File exists mknod: rwd0s4: File exists mknod: wd0s4a: Read-only filesystem mknod: rwd0s4a: Read-only filesystem ...and so on... mknod: wd0s4h: Read-only filesystem mknod: rwd0s4h: Read-only filesystem My hard drive is set up as follows: Western Digital Caviar 2.5GB EIDE, split into 4 partitions 1 Pri-DOS 402Mb 2 Ext-DOS 1201Mb Logical D: 406Mb Logical E: 303Mb Logical F: 404Mb Logical G: 87Mb 3 NTFS 370Mb 4 Non-DOS 469Mb The FreeBSD partition was split up according to the default novice installation values. Any way to fix this? Or do I have to re-install FreeBSD (for the 3rd time)? One note: I can't use the Fixit floppy unless someone makes a 5 1/4" disk image, because my 5 1/4" drive is drive A: (floppy cable is too short), and I installed FreeBSD by using System Commander's boot-from-floppy-in-drive-b: option. My bios can't swap drive letters, so when the install floppy looks for the fixit floppy, it looks in my 5 1/4" drive. Thanks in advance, --Ludwig Pummer ----------------------------------------------------------------- ludwigp@sns.com ICQ UIN: 692441 http://chipweb.home.ml.org http://www.sns.com/~ludwigp <--^-- Updated 11/22/96 PGP Key & Geek Code available on web page
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3.0.32.19970416203623.00818810>