Date: Thu, 14 Dec 2006 19:05:04 -0800 From: =?ISO-8859-1?Q?Ask_Bj=F8rn_Hansen?= <ask@develooper.com> To: freebsd-net@freebsd.org Cc: freebsd-stable@freebsd.org Subject: CARP + VLAN = kernel dump Message-ID: <F66F3EDD-ED08-4EE5-B59E-BB30D88652FB@develooper.com>
next in thread | raw e-mail | index | archive | help
Hi,
If I enable carp on a vlan interface in rc.conf the kernel goes
boom. This is 6.2-RC from a couple of weeks ago. (IIRC then I had
the same problem setting up carp on a bridge'd interface).
I'm configuring it like this:
ifconfig_vlan2="inet 10.50.0.3/24 vlan 202 vlandev sis2"
ifconfig_carp2="vhid 3 advskew 200 pass awe4jkfha4jkfha4f 10.50.0.1"
cloned_interfaces="... carp2 ... vlan2"
However, if I do the carp2 setup "manually" after the system is
booted, it is working fine.
ifconfig carp2 vhid 3 advskew 200 pass hjarefhakjewfha 10.50.0.1
Any ideas?
(kernel dump below)
- ask
fault virtual address = 0x100005c
fault code = supervisor read, page not present
instruction pointer = 0x20:0xc05ba533
stack pointer = 0x28:0xc7975c30
frame pointer = 0x28:0xc7975c90
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 13 (swi1: net)
trap number = 12
panic: page fault
Uptime: 17s
Cannot dump. No dump device defined.
--
http://develooper.com/ - http://askask.com/
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?F66F3EDD-ED08-4EE5-B59E-BB30D88652FB>