Date: Fri, 30 Nov 2001 21:32:59 +0100 From: Morsal Roudbay <morsal@swipnet.se> To: Lawrence Farr <freebsd-net@epcdirect.co.uk> Cc: "'Kristian K. Nielsen'" <freebsd@jkkn.dk>, freebsd-stable@freebsd.org Subject: Re: 4.4-STABLE crashes - suspects new ata-driver over wd-driver Message-ID: <20011130203259.GA35649@zigman.2y.net> In-Reply-To: <003501c178d0$0718c8c0$c806a8c0@lfarr> References: <20011129104514.GA25415@zigman.2y.net> <003501c178d0$0718c8c0$c806a8c0@lfarr>
next in thread | previous in thread | raw e-mail | index | archive | help
Yes.. the PSU is a 300W unit made by AOpen... the server works flawless as
long as I dont use the IDE drives too heavily. It only crashes when I do
heavy IO on the IDE drives... for isntance ports (/usr/ports is on a IDE
drive) as I mentioned earlier.
On Thu, Nov 29, 2001 at 12:19:00PM -0000, Lawrence Farr wrote:
> As in powers off? How bigs the PSU?
>
> Lawrence Farr
> EPC Direct Limited
>
> > -----Original Message-----
> > From: owner-freebsd-stable@FreeBSD.ORG
> > [mailto:owner-freebsd-stable@FreeBSD.ORG] On Behalf Of Morsal Roudbay
> > Sent: 29 November 2001 10:45
> > To: Kristian K. Nielsen
> > Cc: freebsd-stable@FreeBSD.ORG
> > Subject: Re: 4.4-STABLE crashes - suspects new ata-driver
> > over wd-driver
> >
> >
> > I seem to have the same problem... when my IDE drive is under
> > heavy use the
> > whole computer goes down. :( It's my server so it's very
> > serious. My root
> > partition is a SCSI drive.. the IDE drive is only used for
> > ports... and the
> > computer often shuts down when I run the command "portsdb
> > -uU"... (heavy
> > disk usage)
> >
> >
> > On Sat, Oct 13, 2001 at 03:06:56PM +0200, Kristian K. Nielsen wrote:
> > > Hey,
> > >
> > > Motherboard hardware: ASUS P2B with ASUS latest BIOS update 1012
> > >
> > > Recently I upgraded my good FreeBSD server from 3.5-STABLE
> > to 4.4-STABLE and
> > > after
> > > that the kernel has constantly being panicing.
> > > Before upgrading I never have had unexpected kernel panics
> > - now the box
> > > goes down
> > > with a day.
> > > I suspects the new ata-driver since the panics seem to
> > happened when there
> > > is most disk
> > > activity like seeks or copying lots of data from one place
> > to another.
> > >
> > > The panic could look like this - here stangely in an
> > inactive RealServer
> > > (but seem to happen in any running process not nesserily
> > the one causing the
> > > diskactivity):
> > >
> > > IdlePTD 3276800
> > > initial pcb at 2966c0
> > > panicstr: page fault
> > > panic messages:
> > > ---
> > > Fatal trap 12: page fault while in kernel mode
> > > fault virtual address = 0x7145cfb0
> > > fault code = supervisor read, page not present
> > > instruction pointer = 0x8:0xc01496d2
> > > stack pointer = 0x10:0xd720ef20
> > > frame pointer = 0x10:0xd720ef38
> > > code segment = base 0x0, limit 0xfffff, type 0x1b
> > > = DPL 0, pres 1, def32 1, gran 1
> > > processor eflags = interrupt enabled, resume, IOPL = 0
> > > current process = 364 (rmserver)
> > > interrupt mask = none
> > > trap number = 12
> > > panic: page fault
> > >
> > > syncing disks... 104 13 10 9 8
> > > done
> > > Uptime: 18h53m51s
> > >
> > > --------
> > >
> > > dmesg returns:
> > > Copyright (c) 1992-2001 The FreeBSD Project.
> > > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991,
> > 1992, 1993, 1994
> > > The Regents of the University of California. All
> > rights reserved.
> > > FreeBSD 4.4-STABLE #0: Wed Oct 10 23:33:25 CEST 2001
> > > jkkn@jkkn.jkkn.net:/usr/src/sys/compile/JKKN_KRNL
> > > Timecounter "i8254" frequency 1193182 Hz
> > > Timecounter "TSC" frequency 300683475 Hz
> > > CPU: Pentium II/Pentium II Xeon/Celeron (300.68-MHz 686-class CPU)
> > > Origin = "GenuineIntel" Id = 0x634 Stepping = 4
> > >
> > >
> > Features=0x80f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,
> > PGE,MCA,CMOV,M
> > > MX>
> > > real memory = 402640896 (393204K bytes)
> > > avail memory = 387919872 (378828K bytes)
> > > Preloaded elf kernel "kernel" at 0xc0301000.
> > > Pentium Pro MTRR support enabled
> > > Using $PIR table, 6 entries at 0xc00f0d10
> > > npx0: <math processor> on motherboard
> > > npx0: INT 16 interface
> > > pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
> > > pci0: <PCI bus> on pcib0
> > > pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at
> > device 1.0 on pci0
> > > pci1: <PCI bus> on pcib1
> > > isab0: <Intel 82371AB PCI to ISA bridge> at device 4.0 on pci0
> > > isa0: <ISA bus> on isab0
> > > atapci0: <Intel PIIX4 ATA33 controller> port 0xd800-0xd80f
> > at device 4.1 on
> > > pci0
> > > ata0: at 0x1f0 irq 14 on atapci0
> > > ata1: at 0x170 irq 15 on atapci0
> > > pci0: <Intel 82371AB/EB (PIIX4) USB controller> at 4.2
> > > chip1: <Intel 82371AB Power management controller> port
> > 0xe800-0xe80f at
> > > device 4.3 on pci0
> > > rl0: <RealTek 8139 10/100BaseTX> port 0xd000-0xd0ff mem
> > > 0xe3000000-0xe30000ff irq 10 at device 10.0 on pci0
> > > rl0: Ethernet address: 00:40:95:30:2e:5e
> > > miibus0: <MII bus> on rl0
> > > rlphy0: <RealTek internal media interface> on miibus0
> > > rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
> > > pci0: <S3 ViRGE DX/GX graphics accelerator> at 12.0 irq 11
> > > orm0: <Option ROM> at iomem 0xc0000-0xc7fff on isa0
> > > fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6
> > drq 2 on isa0
> > > fdc0: FIFO enabled, 8 bytes threshold
> > > fd0: <1440-KB 3.5" drive> on fdc0 drive 0
> > > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
> > > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem
> > 0xa0000-0xbffff on isa0
> > > sc0: <System console> at flags 0x100 on isa0
> > > sc0: VGA <16 virtual consoles, flags=0x300>
> > > sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
> > > sio0: type 16550A
> > > sio1 at port 0x2f8-0x2ff irq 3 on isa0
> > > sio1: type 16550A
> > > ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
> > > ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
> > > ppc0: FIFO with 16/16/9 bytes threshold
> > > lpt0: <Printer> on ppbus0
> > > lpt0: Interrupt-driven port
> > > ppi0: <Parallel I/O> on ppbus0
> > > IPsec: Initialized Security Association Processing.
> > > ad0: 8207MB <ST38641A> [16676/16/63] at ata0-master UDMA33
> > > ad2: 9641MB <IBM-DTTA-371010> [19590/16/63] at ata1-master UDMA33
> > > acd0: CD-RW <CD-RW CRX100E> at ata1-slave using PIO4
> > > Mounting root from ufs:/dev/ad0s1a
> > >
> > >
> > > -----
> > >
> > >
> > > (kgdb) where
> > > #0 dumpsys () at ../../kern/kern_shutdown.c:473
> > > #1 0xc0143efc in boot (howto=256) at ../../kern/kern_shutdown.c:313
> > > #2 0xc01442dc in poweroff_wait (junk=0xc02711ac, howto=-1071182641)
> > > at ../../kern/kern_shutdown.c:581
> > > #3 0xc023b07f in trap_fatal (frame=0xd720eee0, eva=1900400560)
> > > at ../../i386/i386/trap.c:956
> > > #4 0xc023ad39 in trap_pfault (frame=0xd720eee0,
> > usermode=0, eva=1900400560)
> > > at ../../i386/i386/trap.c:849
> > > #5 0xc023a90f in trap (frame={tf_fs = 16, tf_es = -685768688, tf_ds
> > > = -685768688,
> > > tf_edi = 753273225, tf_esi = 1900400556, tf_ebp = -685707464,
> > > tf_isp = -685707508, tf_ebx = 4, tf_edx = -685707516,
> > tf_ecx = 59999,
> > > tf_eax = 4, tf_trapno = 12, tf_err = 0, tf_eip =
> > -1072392494, tf_cs =
> > > 8,
> > > tf_eflags = 66066, tf_esp = -755888352, tf_ss = 2})
> > > at ../../i386/i386/trap.c:448
> > > #6 0xc01496d2 in nanosleep (p=0xd2f20f20, uap=0xd720ef80)
> > > at ../../kern/kern_time.c:283
> > > #7 0xc023b2e1 in syscall2 (frame={tf_fs = 47, tf_es = 47, tf_ds
> > > = -1078001617,
> > > tf_edi = 0, tf_esi = 60000, tf_ebp = -1077937184,
> > tf_isp = -685707308,
> > > tf_ebx = 673886912, tf_edx = -1, tf_ecx = 4, tf_eax =
> > 240, tf_trapno =
> > > 22,
> > > tf_err = 2, tf_eip = 673632288, tf_cs = 31, tf_eflags = 659,
> > > tf_esp = -1077937220, tf_ss = 47}) at
> > ../../i386/i386/trap.c:1155
> > > #8 0xc022f8a5 in Xint0x80_syscall ()
> > > #9 0x8074fd6 in ?? ()
> > > #10 0x8075302 in ?? ()
> > > #11 0x80728cd in ?? ()
> > > #12 0x8076d8b in ?? ()
> > > ---Type <return> to continue, or q <return> to quit---
> > > #13 0x804fa3d in ?? ()
> > > #14 0x804eb7d in ?? ()
> > >
> > >
> > > -----
> > >
> > >
> > > For more information - please contact me at freebsd@jkkn.net
> > >
> > >
> > > I apreciate any help,
> > >
> > > Kristian K. Nielsen
> > >
> > >
> > >
> >
> > To Unsubscribe: send mail to majordomo@FreeBSD.org
> > with "unsubscribe freebsd-stable" in the body of the message
> >
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20011130203259.GA35649>