Date: Sat, 8 Sep 2012 09:14:29 -0700 From: Adrian Chadd <adrian@freebsd.org> To: =?ISO-8859-1?Q?Alexander_K=FChn?= <alexander.kuehn@nagilum.de> Cc: freebsd-wireless@freebsd.org Subject: Re: kern/167491: [ath] TID != hardware queue TID in ath_tx_aggr_comp_aggr() Message-ID: <CAJ-VmomLJ5HObsooDc9piuz0FoS60d_hpqNn2Q5u4sqmyiGetw@mail.gmail.com> In-Reply-To: <201209080950.q889o7I2040830@freefall.freebsd.org> References: <201209080950.q889o7I2040830@freefall.freebsd.org>
next in thread | previous in thread | raw e-mail | index | archive | help
Hi, COmpile/run athsurvey; paste the results here. src/tools/tools/ath/athsurvey/ Adrian On 8 September 2012 02:50, Alexander K=FChn <alexander.kuehn@nagilum.de> wr= ote: > The following reply was made to PR kern/167491; it has been noted by GNAT= S. > > From: Alexander =3D?iso-8859-1?b?S/xobg=3D=3D?=3D <alexander.kuehn@nagilu= m.de> > To: bug-followup@FreeBSD.org > Cc: > Subject: Re: kern/167491: [ath] TID !=3D hardware queue TID in > ath_tx_aggr_comp_aggr() > Date: Sat, 08 Sep 2012 11:42:47 +0200 > > I see the same on x86 along with: > > messages.4.bz2:Sep 2 17:04:29 cakebox kernel: ath0: stuck beacon; > resetting (bmiss count 4) > messages.4.bz2:Sep 2 17:04:33 cakebox kernel: ath0: stuck beacon; > resetting (bmiss count 4) > messages.4.bz2:Sep 2 17:04:33 cakebox kernel: ath0: ath_start: > sc_inreset_cnt > 0; bailing > messages.4.bz2:Sep 2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain: > node 0xc47ea000: bf=3D0xc350fcc0: addbaw=3D0, dobaw=3D0, seqno=3D0, retr= y=3D0 > messages.4.bz2:Sep 2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain: > node 0xc47ea000: bf=3D0xc350fcc0: tid txq_depth=3D1 hwq_depth=3D0, bar_w= ait=3D0 > messages.4.bz2:Sep 2 17:05:12 cakebox kernel: ath0: ath_tx_tid_drain: > node 0xc47ea000: tid 16: txq_depth=3D64, txq_aggr_depth=3D0, sched=3D0, > paused=3D0, hwq_depth=3D0, incomp=3D0, baw_head=3D0, baw_tail=3D0 txa_st= art=3D-1, > ni_txseqs=3D7 > messages.4.bz2:Sep 2 17:06:25 cakebox kernel: ath0: stuck beacon; > resetting (bmiss count 4) > > Unfortunately this causes the transfer rates to drop and occasionally > even makes it impossible to associate with the AP. > > dmesg: > Copyright (c) 1992-2012 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > The Regents of the University of California. All rights reserve= d. > FreeBSD is a registered trademark of The FreeBSD Foundation. > FreeBSD 10.0-CURRENT #0: Wed Aug 29 13:01:13 CEST 2012 > root@cakebox.tis:/usr/obj/export/src/sys/net5501 i386 > CPU: Geode(TM) Integrated Processor by AMD PCS (499.91-MHz 586-class CPU= ) > Origin =3D "AuthenticAMD" Id =3D 0x5a2 Family =3D 5 Model =3D a S= tepping =3D 2 > Features=3D0x88a93d<FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CLFLUSH,MMX> > AMD Features=3D0xc0400000<MMX+,3DNow!+,3DNow!> > real memory =3D 536870912 (512 MB) > avail memory =3D 515837952 (491 MB) > K6-family MTRR support enabled (2 registers) > cryptosoft0: <software crypto> on motherboard > pcib0 pcibus 0 on motherboard > pci0: <PCI bus> on pcib0 > Geode LX: Soekris net5501 comBIOS ver. 1.33 20070103 Copyright (C) 2000-= 2007 > glxsb0: <AMD Geode LX Security Block (AES-128-CBC, RNG)> mem > 0xa0000000-0xa0003fff irq 10 at device 1.2 on pci0 > vr0: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe100-0xe1ff mem > 0xa0004000-0xa00040ff irq 11 at device 6.0 on pci0 > vr0: Quirks: 0x2 > vr0: Revision: 0x96 > miibus0: <MII bus> on vr0 > ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0 > ukphy0: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto, aut= o-flow > vr0: Ethernet address: 00:00:24:cb:a6:80 > vr1: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe200-0xe2ff mem > 0xa0004100-0xa00041ff irq 5 at device 7.0 on pci0 > vr1: Quirks: 0x2 > vr1: Revision: 0x96 > miibus1: <MII bus> on vr1 > ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1 > ukphy1: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto, aut= o-flow > vr1: Ethernet address: 00:00:24:cb:a6:81 > vr2: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe300-0xe3ff mem > 0xa0004200-0xa00042ff irq 9 at device 8.0 on pci0 > vr2: Quirks: 0x2 > vr2: Revision: 0x96 > miibus2: <MII bus> on vr2 > ukphy2: <Generic IEEE 802.3u media interface> PHY 1 on miibus2 > ukphy2: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto, aut= o-flow > vr2: Ethernet address: 00:00:24:cb:a6:82 > vr3: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe400-0xe4ff mem > 0xa0004300-0xa00043ff irq 12 at device 9.0 on pci0 > vr3: Quirks: 0x2 > vr3: Revision: 0x96 > miibus3: <MII bus> on vr3 > ukphy3: <Generic IEEE 802.3u media interface> PHY 1 on miibus3 > ukphy3: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto, aut= o-flow > vr3: Ethernet address: 00:00:24:cb:a6:83 > ath0: <Atheros 5416> mem 0xa0010000-0xa001ffff irq 10 at device 14.0 on = pci0 > ath0: DMA setup: legacy > ath0: [HT] enabling HT modes > ath0: [HT] RTS aggregates limited to 8 KiB > ath0: [HT] 2 RX streams; 2 TX streams > ath0: AR5416 mac 13.10 RF2133 phy 8.1 > ath0: 2GHz radio: 0x0000; 5GHz radio: 0x00d0 > isab0: <PCI-ISA bridge> at device 20.0 on pci0 > isa0: <ISA bus> on isab0 > atapci0: <AMD CS5536 UDMA100 controller> port > 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xe000-0xe00f at device 20.2 on pci0 > ata0: <ATA channel> at channel 0 on atapci0 > ata1: <ATA channel> at channel 1 on atapci0 > ohci0: <OHCI (generic) USB controller> mem 0xa0020000-0xa0020fff irq > 15 at device 21.0 on pci0 > usbus0 on ohci0 > ehci0: <AMD CS5536 (Geode) USB 2.0 controller> mem > 0xa0021000-0xa0021fff irq 15 at device 21.1 on pci0 > usbus1: EHCI version 1.0 > usbus1 on ehci0 > cpu0 on motherboard > orm0: <ISA Option ROM> at iomem 0xc8000-0xd27ff pnpid ORM0000 on isa0 > atrtc0: <AT realtime clock> at port 0x70 irq 8 on isa0 > Event timer "RTC" frequency 32768 Hz quality 0 > attimer0: <AT timer> at port 0x40 on isa0 > Timecounter "i8254" frequency 1193182 Hz quality 0 > Event timer "i8254" frequency 1193182 Hz quality 100 > uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 4 flags 0x10 on isa= 0 > uart0: console (19200,n,8,1) > uart1: <16550 or compatible> at port 0x2f8-0x2ff irq 3 on isa0 > Timecounters tick every 1.000 msec > usbus0: 12Mbps Full Speed USB v1.0 > usbus1: 480Mbps High Speed USB v2.0 > ugen0.1: <AMD> at usbus0 > uhub0: <AMD OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus0 > ugen1.1: <AMD> at usbus1 > uhub1: <AMD EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus1 > ad0: 152627MB <SAMSUNG HM160HC LQ100-10> at ata0-master UDMA100 > GEOM_SCHED: Initializing global data. > GEOM_SCHED: Loading: mp =3D 0xc0a9aa20, g_sched_class =3D 0xc0a9aa20. > Timecounter "TSC" frequency 499912531 Hz quality 800 > uhub0: 4 ports with 4 removable, self powered > Root mount waiting for: usbus1 > uhub1: 4 ports with 4 removable, self powered > _______________________________________________ > freebsd-wireless@freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-wireless > To unsubscribe, send any mail to "freebsd-wireless-unsubscribe@freebsd.or= g"
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?CAJ-VmomLJ5HObsooDc9piuz0FoS60d_hpqNn2Q5u4sqmyiGetw>