Date: Tue, 19 Dec 2000 21:19:06 -0500 From: Dragan Mickovic <dmickovic@verio.net> To: freebsd-mobile@freebsd.org Subject: PCMCIA NIC on Sony VIAO Message-ID: <20001219211906.A52729@hway.net>
next in thread | raw e-mail | index | archive | help
I have Sony VIAO PCG-F650 with the following:
pcic-pci0: <Ricoh RL5C478 PCI-CardBus Bridge> at device 12.0 on pci0
pcic-pci1: <Ricoh RL5C478 PCI-CardBus Bridge> at device 12.1 on pci0
pcic0: <Intel i82365> at port 0x3e0 iomem 0xd0000 irq 10 on isa0
pcic0: management irq 10
pccard0: <PC Card bus -- kludge version> on pcic0
pccard1: <PC Card bus -- kludge version> on pcic0
When I try to install Xircom CreditCard CE3-100 it finds the pcmcia card
as:
pccardd[186]: Card "Xircom"("CeditCard 10/100") [CE3-10/100][1.00] matched
"Xircom" ("CreditCard 10/100") [(null)][(null)]
pccardd[186]: driver allocation faild for Xircom(CreditCard 10/100): Device
not configured.
under /etc/defaults/pccard.conf i have:
# Xircom CreditCard Ethernet 10/100
card "Xircom" "CreditCard 10/100"
config 0x1 "xe0" ?
insert /etc/pccard_ether $device start
remove /etc/pccard_ether $device stop
and here is a: pccardc dumpcis
Code 136 not found
Code 136 not found
code Unknown ignored
Code 138 not found
Code 138 not found
code Unknown ignored
Configuration data for card in slot 0
Tuple #1, code = 0x1 (Common memory descriptor), length = 2
000: 00 ff
Common memory device information:
Device number 1, type No device, WPS = OFF
Speed = No speed, Memory block size = reserved, 32 units
Tuple #2, code = 0x17 (Attribute memory descriptor), length = 2
000: 00 ff
Attribute memory device information:
Device number 1, type No device, WPS = OFF
Speed = No speed, Memory block size = reserved, 32 units
Tuple #3, code = 0x15 (Version 1 info), length = 44
000: 05 00 58 69 72 63 6f 6d 00 43 72 65 64 69 74 43
010: 61 72 64 20 31 30 2f 31 30 30 00 43 45 33 2d 31
020: 30 2f 31 30 30 00 31 2e 30 30 00 ff
Version = 5.0, Manuf = [Xircom], card vers = [CreditCard 10/100]
Addit. info = [CE3-10/100],[1.00]
Tuple #4, code = 0x0 (Null tuple), length = 8
000: 2a 81 a9 00 00 00 00 00
Tuple #5, code = 0x20 (Manufacturer ID), length = 5
000: 05 01 0a 01 43
PCMCIA ID = 0x105, OEM ID = 0x10a
Tuple #6, code = 0x44 (Card init date), length = 4
000: ec 45 31 29
Tuple #7, code = 0x1a (Configuration map), length = 5
000: 01 01 00 08 03
Reg len = 2, config register addr = 0x800, last config = 0x1
Registers: XX------
Tuple #8, code = 0x1b (Configuration entry), length = 25
000: c1 c1 bd 7f 55 4d 5d 3e 46 46 06 e0 17 17 e4 60
010: 00 00 0f 70 bc 8e 10 00 20
Config index = 0x1(default)
Interface byte = 0xc1 (I/O) +RDY/-BSY active, wait signal supported
Vcc pwr:
Nominal operating supply voltage: 5 x 1V
Minimum operating supply voltage: 4.5 x 1V
Maximum operating supply voltage: 5.5 x 1V
Continuous supply current: 3.5 x 100mA
Max current average over 1 second: 4 x 100mA
Max current average over 10 ms: 4 x 100mA
Power down supply current: 1 x 100mA
Wait scale Speed = 1.2 x 10 ms
RDY/BSY scale Speed = 1.2 x 10 ms
Card decodes 4 address lines, full 8/16 Bit I/O
I/O address # 1: block start = 0x0 block length = 0x10
IRQ modes: Level, Pulse
IRQs: 2 3 4 5 7 9 10 11 15
Memory space length = 0x10
Max twin cards = 0
Misc attr: (Power down supported)
Tuple #9, code = 0x21 (Functional ID), length = 2
000: 06 00
Network/LAN adapter
Tuple #10, code = 0x22 (Functional EXT), length = 8
000: 04 06 00 10 a4 a9 81 2a
Network node ID: 00 10 a4 a9 81 2a
Tuple #11, code = 0x22 (Functional EXT), length = 2
000: 01 02
Network technology: Ethernet
Tuple #12, code = 0x22 (Functional EXT), length = 5
000: 02 80 96 98 00
Network speed: 10 Mb/sec
Tuple #13, code = 0x22 (Functional EXT), length = 5
000: 02 00 e1 f5 05
Network speed: 100 Mb/sec
Tuple #14, code = 0x22 (Functional EXT), length = 2
000: 03 01
Network media: UTP
Tuple #15, code = 0x22 (Functional EXT), length = 2
000: 03 03
Network media: Thin coax
Tuple #16, code = 0x22 (Functional EXT), length = 2
000: 05 00
Network connector: open connector standard
Tuple #17, code = 0x0 (Null tuple), length = 12
000: 32 30 30 30 33 46 41 39 38 31 32 41
Tuple #18, code = 0xff (Terminator), length = 0
2 slots found
HELP :-)
--
Dragan Mickovic
UNIX Systems Administrator
Verio, Inc. x.4012
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20001219211906.A52729>