Date: Fri, 20 Jun 2014 09:53:42 -0500 From: Michael Gass <mgass@csbsju.edu> To: Warren Block <wblock@wonkity.com> Cc: freebsd-stable@freebsd.org Subject: Re: New Xorg with vt, radeon, and 10-stable Message-ID: <20140620145342.GA11837@csbsju.edu> In-Reply-To: <alpine.BSF.2.11.1406190851510.55091@wonkity.com> References: <20140618231418.GA15764@csbsju.edu> <alpine.BSF.2.11.1406181950110.51000@wonkity.com> <20140619140226.GB11623@csbsju.edu> <alpine.BSF.2.11.1406190851510.55091@wonkity.com>
next in thread | previous in thread | raw e-mail | index | archive | help
On Thu, Jun 19, 2014 at 08:54:12AM -0600, Warren Block wrote: > On Thu, 19 Jun 2014, Michael Gass wrote: > > >>As far as I know, that will work with vt(4). However, you must > >>build a kernel with vt(4) instead of syscons(4). And it requires > >>9-STABLE, 10-STABLE, or newer. > > > >Thanks Warren. I will give it a try. > > There is a sample kernel config file in 9- and 10-stable called > "VT". It really just turns off the sc(4) and vga(4) modules and > enables vt(4) and vt_vga, which is easy to do in custom kernel > config files also. Hi Warren. Thanks for the response. This works well except for one problem. The kernel rebuild went fine and vt_vga worked during the boot process. Tried kldload radeonkms and that worked well also. So I put radeonkms_load="YES" in loader.conf and then the boot process crashes. There is no dmesg available, but I can see the following error messages on the screen. error: [drm:pid0:r600_init_microcode] *ERROR* r600_cp: Failed to load firmware "radeonkmsfw_RV610_pfp" error: [drm:pid0:r600_startup] *ERROR* Failed to load firmware! drmn0: error: disabling GPU acceleration error: [drm:pid0:r600_init] *ERROR* radeon: ucode required for R600+ drmn0: error: Fatal error during GPU init I used a rescue cd to change loader.conf and get the system working again. I do not understand what the probem is, since radeonkms will work with kldload. I can also switch back and forth from X to vt without problem now. My graphics card is AMD RV610 HD 2400 PRO/XT I'm running FreeBSD 10.0-stable on an amd64 machine. I built everything with the lines WITH_NEW_XORG=yes WITH_GALLIUM=yes in make.conf Any advice? Thanks, Mike
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20140620145342.GA11837>