Date: Mon, 31 Aug 1998 11:25:16 +0200 (MET DST) From: "D. Rock" <rock@cs.uni-sb.de> To: Zach Heilig <zach@gaffaneys.com> Cc: freebsd-current@FreeBSD.ORG Subject: Re: printer didn't work after cvsup Message-ID: <13802.27355.871373.199447@doom> In-Reply-To: <19980831024552.A912@znh.org.> References: <35E13ACB.10D29949@wurzelausix.cs.uni-sb.de> <19980830172105.51414@breizh.prism.uvsq.fr> <19980831024552.A912@znh.org.>
next in thread | previous in thread | raw e-mail | index | archive | help
Zach Heilig writes: > On Sun, Aug 30, 1998 at 05:21:05PM +0000, Nicolas Souchu wrote: > > Ok. When do you see the leds coming up again? I propose you to remove the > > pnp_detect() call from /sys/dev/ppbus/ppbconf.c and tell me. > > I've seen this as well, but I thought it was just my configuration (tweeking > the bios a bit fixed it). > > EPP only works (detected as): > ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode > > EPP/ECP doesn't work (similar to, but with ECP/PS2 added). > ppc0: Generic chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode Exactly the same for my configuration. I installed the system from a "make release" at Aug, 21. The printer only works if ECP is disabled. I have a parallel port ZIP drive attached (ick). There is an interesting phenomen: If I enable ECP, the printer port gets detected (Winbond W83877F on a VIA Apollo Master board), but the ZIP drive doesn't. After a reboot, even the BIOS doesn't find the parallel port any more. I have to do a power cycle to revive it again. Daniel To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?13802.27355.871373.199447>